Estimate the viscosity of water at 30 degree c

Assignment Help Civil Engineering
Reference no: EM13320801

The dynamic viscosity of water at 20°C is 1.00 x 10-3 N-s/m2, and the viscosity at 40°C is 6.53 x 10-4 N-s/m2. Estimate the viscosity at 30°C.

Reference no: EM13320801

Questions Cloud

Determine how many tons of aggregate will be needed : Base course aggregate has a target dry density of 119.7 lb/cu ft in place. It will be laid down and compacted in a rectangular street repair area of 2000 ft*48ft*6in.
What is the total work done by the two tugboats : Two tugboats pull a disabled supertanker. Each tug exerts a construct force of 2.00 x 10^6 N, What is the total work done by the two tugboats on the supertanker
What torque is required to drive the disk at 760 rpm : A flat disk spins within an oil-filled enclosure. Clearances between the enclosure to both sides of the disk is 2.3 mm. The disk surface (area subject to shear) extends from radius 10mm to 90 mm.
Discuss how the marketing strategy : You have been hired as the marketing manager. Research and identify major approaches of how innovations like these are adopted by consumers. Discuss how the marketing strategy for the car needs to rapidly move through these processes.
Estimate the viscosity of water at 30 degree c : The dynamic viscosity of water at 20°C is 1.00 x 10-3 N-s/m2, and the viscosity at 40°C is 6.53 x 10-4 N-s/m2. Estimate the viscosity at 30°C.
What is the permeability : An iron-core solenoid is 43cm long and 1.7cm in diameter, and has 720 turns of wire. What is the permeability %u03BC at this high field strength
What will be the percentage decrease in specific volume : Water in a hydraulic press is subjected to a pressure of 4500 psia at 68 degrees F. If the initial pressure is 15 psia, approximately what will be the percentage decrease in specific volume
Determine the phase angle of the source voltage : An LRC series circuit with R = 100 Omega, L = 56mH, and C =1.7 muF is powered by an ac voltage source of peak voltage V0 = 210 V,  Determine the phase angle of the source voltage relative to the current
Consumer behaviour and retail marketing strategy : CONSUMER BEHAVIOUR AND RETAIL MARKETING STRATEGY

Reviews

Write a Review

Civil Engineering Questions & Answers

  Find what is the total distance during the time interval t

The velocity of a particle traveling along a straight line is v=(3t^2-6t) ft/s , where t is in seconds. if s=4ft when t=0 determine the position of the particle when t=4s what is the total distance during the time interval t=0 to t=4s

  Determine the relative humidity using psychrometric chart

The wet bulb and dry bulb temperatures for humid atmospheric air (at 100 kPa) are measured to be 20 C and 25C respectively. Determine: a. using the psychrometric chart, the relative humidity  b. using the psychrometric chart, the humidity ratio

  Determine the weight of the water and the pressure forces

A 30-ft-high, 1-ft-diameter pipe is welded to the top of a cubic container 13 ft * 3 ft * 3 ft2. The container and pipe are filled with water at 20°C. Determine the weight of the water and the pressure forces on the bottom and sides of the contain..

  What is the angular velocity of the carriers

If the outer ring rotates in the clockwise direction at 7 rpm and the inner ring rotates in the counterclockwise direction at 12 rpm, what is the angular velocity of the carriers and what is the velocity of C, the center of the top carrier.

  Determine the change in enthalpy and the head loss in db

Oxygen flows without a gain or loss of heat through a horizontal pipe of constant cross section. At section 1 the pressure 175 psia, the velocity is 78 fps, and the temperature is 50°F; at section 2 the pressure is 130 psia

  Design flow of cfs and design the channel section

An earthen channel will be excavated into sandy soil for which Vmax = 4.0 ft/sec, n=0.022 and the recommended m=3. The channel will have a bottom slope of 0.0011 and accommodate a design flow of 303 cfs. Design (size) the channel section.

  Environmental soil cleaning company

How much money should an environmental soil cleaning company borrow to finance a site reclamation project if it expects revenue of $140,000 in the first year increasing by 3% per year over the 5-year cleanup period? The interest rate is 8%.

  Determine a complete set of dimensionless parameters

Water flows over a dam. Assume the volume flowrate per unit length q along the dam is a function of the head h , width b, acceleration of gravity g, f luid density and the fluid viscosity. Determine a complete set of dimensionless parameters

  Overall gear reduction ratio

If the overall gear reduction ratio is 8 to 1, what is the maximum acceleration from rest (in ft/sec^2) for: a) the car with the base engine? b) car with the modified engine? Assume the car is on good dry pavement.

  What is the settling velocity of a floc of diameter in water

What is the settling velocity of a floc of diameter 0.15 mm and density 2.12 g/cm3 in water. Will the floc from problem 4 be completely removed in a typical sedimentation basin if alum was used as the coagulant.

  Determine what is the maximum water hammer pressure

0.5 m-diameter concrete pipe (5.0 cm rigid wall thickness with rigid pipe walls) carries water 600m before discharging into another reservoir. The surface elevation of the downstream reservoir is 55 m lower than the supply reservoir.

  What percentage of the water evaporates

Saturated liquid water at 1.0 MPa is throttled adiabatically to a pressure of 0.4 MPa. If the change is kinetic energy is negligible, what percentage of the water evaporates during this throttling process?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd