Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 250 mm- diameter and 16 m-long timber pile is driven into a sandy soil where f= 18 kN/m3 and f' = 34 degree. Estimate the maximum load allowed on the pile with a safety factor of 2.5 . For the problem compare two cases: case 1 where the water table is deep, and case 2 where the water table is a ground level.
calculate the ratio of area to volume for unit cube a unit sphere in inscribed inside the cube, and as write cylinder inscribed inside the cube.
When using singularity functions, if I have a reactionary moment at a cantilever connection, do I use the right hand rule to solve the moment and determine it's direction through the reactions
There are three reactors degrading a chemical biologically, at three degradation rates; i.e., 0.2 d^-1, 0.4 d^-1, and 1.0 d^-1. The residence time of the chemical in these reactors are 10 d, 5 d, and 55 d, respectively.
Determine the total crop water requirement including the leaching ratio of a corn crop with a ECt of 1.7mmhos cm-1 if the ECiw of the irrigation water and precipitation is 5 and 0 mmhos cm-1 respectively
HOCL is added to water in a tank as a disinfectant. After equilibrium is reached it is found that the pH of the water in the tank is 8.2 and the gas phase partial pressure is the head space of the tank is 0.2E-7 atm.
the coefficient of the restitution for the collision is e = 0.3, and friction is negligible. if the time duration of the collision is 0.025 s, determine the average impact force which is exerted on the 3 kg body.
a piston-and-cylinder device contains 5 kg of water initially at 150 C and 0.20 MPa. The frictionless piston is then pushed slowly in an isothermal process until the volume of water becomes 10% of its initial value.
The static pressures upstream and downstream of the screen are 0.2 and 0.15 psi and are uniformly distributed over the flow cross section area. Neglecting the force exerted by the duct wall on the flowing air, calculate the screen drag force.
The coefficient of friction between the crate and the floor is µs = 0.4 and µk = 0.3. If P is slowly increased until the crate starts to move and then remains constant, determine using energy methods the speed of the crate after moving 2 m.
a 3000 lb car has a maximum speed of 140 mi/h with 16-in radius wheels, a gear reduction of 3.5 to 1, and a drivetrain efficiency of 92%. it is known that at the cars top speed the engine is producing 220 ft-lb of torque.
Give one possible characteristic or property of sanstone and of the quartzite that made you decide not to select it for your concrete project?
A lagoon with a volume of 1200 m^3 has been receiving a steady flow of a conservative waste at a rate of 100m^3/day for a long enough time to assume that steady-state conditions apply. The waste entering the lagoon has a concentration of 10mg/L.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd