Estimate the excess pore pressure distribution in clay layer

Assignment Help Civil Engineering
Reference no: EM13320958

At the site of a large scale land reclamation project 2 m of sand overlie a silty clay layer 5 m thick, which overlies highly fractured permeable rock. The project involved rapidly placing 5 m of fill over a large area that applied a stress of 100 kPa to the underlying soil. It was initially expected that after 2 years consolidation would be complete. However, after 2 years the excess pore pressures in the silty clay layer were still significant and had the values shown in the table below.
Depth below
top of clay layer (m) Excess pore pressure(kPa)
0 0
1 25
2 40
3 50
4 40
5 25
6 0

To speed up consolidation it is proposed to place additional fill, starting at t = 2 years, so that the stress on the clay increases at a rate of 10kPa/month for 6 months, at which time all the additional load will be removed.

a.Assuming that consolidation is occurring under 1-Dimensional conditions show that the pore pressures measured at 2 years are consistent with a cv of approximately 1.7 m2/yr.

b.Use a numerical method to estimate the excess pore pressure distribution in the clay layer between 2 years and 2.5 years from the start of the land reclamation, and hence determine the settlement at 2.5 years. Use ?t = 2 months, ?z = 1 m, and take mv = 0.0001 m2/kN.

Reference no: EM13320958

Questions Cloud

Explain what is the empirical formula of the compound : A 1.5991 g sample of a hydrocarbon is combusted to give 1.6918 g of H2O and 5.1661 g of CO2. What is the empirical formula of the compound
Define consumer behavior : Define Consumer Behavior. Explain the three ways of doing business. Explain the ways CB is dynamic.
Find a small hole that your work can reasonably fill : Create a clear, concise problem statement - A problem statement may be a couple of sentences but it is definitely not a paragraph in length.
Describe the photoelectric effect : Which of the following is true about the photoelectric effect. a) The number of electrons emitted increases with intensity of light, regardless of the frequency. b) The number of electrons emitted increases with the intensity of light
Estimate the excess pore pressure distribution in clay layer : The project involved rapidly placing 5 m of fill over a large area that applied a stress of 100 kPa to the underlying soil. It was initially expected that after 2 years consolidation would be complete.
According to the law of comparative advantage : According to the law of comparative advantage, what should be the distinguishing characteristics of the goods a nation produces?
Compute the forces fh and fv on the dam and line of action : A dam has a parabolic shape z/zo = (x/xo)2, with xo = 10 ft and zo = 24 ft. The fluid is water, gamma = 62.4 lbf/ft3, and atmospheric pressure may be omitted.
If everyone were to obtain music and video content for free : If everyone were to obtain music and video content for free from websites such as MySpace, instead of paying Universal, what would Universal’s producer surplus be from music sales? What are the implications for Universal’s incentive to produce music ..
Explain what mass of water is required for the formation : The reaction of coal and water at a high temperature produces a mixture of hydrogen and carbon monoxide gases. This mixture is known as synthesis gas (or syngas). What mass of water is required for the formation of 175 grams of carbon monoxide? C(..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Plot the magnitude of the force exerted on the gate

Plot the magnitude of the force exerted on the gate by the brace as a function of the angle of the gate, , for . Assume the weight of the gate is negligible.

  Define mechanical engineering dynamics

Important information about Mechanical engineering dynamics, A 3000 lb car rests on a horizontal street out of gas with its brakes locked.

  How many ton of asphalt concrete will be required to overlay

How many tons of asphalt concrete will be required to overlay a 3-mile-long, 24-ft.-wide road with 2.5 in. of wearing course asphalt concrete that has a density of 146.3 pcf

  What should be the new volume of the lake

Suppose that the distance from the lake outlet to the withdrawal cannot be more than 20 mi. What should be the new volume of the lake?

  Determine the mass and stiffness of the undamped system

The mass m, stiffness k, and natural frequency fn of an undamped SDF system are unknown. These properties are to be determined by harmonic excitation tests. at an excitation frequency of 4 Hz, the response tends to increase without bound.

  What is the maximum distance between the two particles

Before the second particle catches the first particle, what is the maximum distance between the two particles.

  Determine purchasing power 3 years from now of an investment

Determine the purchasing power 3 years from now of an investment of $20,000 today. The investment is earning a market interest rate of 8%, and the inflation rate is 3%.

  Determine what would be the relative compaction in the field

The maximum and minimum dry unit weights of a sand were determined in the laboratory to be 104 lb/ft^3 and 93 lb/ft^3, respectively. what would be the relative compaction in the field if the relative density is 78%

  Determine the normal depth using a converging iteration

A 5-m wide rectangular channel is carrying a flow of 5 cubic meter per second. If the Manning n=0.013 and the bottom slope, So=0.0001, determine the normal depth using a converging iteration.

  Standard test method for flash and fire points

What is the procedure standard test method for flash and fire points by cleveland open cup tester if there is animation or video is better....

  What would the horizontal distance between the two point be

The terrain in the in the immediate area does not allow for level measuring area. if the suveyour verifiies the diffence in elevation between the point measured from. and the point measured to, as 8.93 feet,

  Determine the density on the highway and flow on the road

Traffic data collected at the same time indicated an average time headway of 4 sec. Determine the (a) density on the highway (b) flow on the road (c) space mean speed.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd