Dtermine the resistance values for a voltage divider

Assignment Help Electrical Engineering

Reference no: EM13286031

Dtermine the resistancevalues for avoltage divider that must meet the following specifications. The currrent drain under the unload condition is nit to exceed 5mA. The soure voltage is to be 10V and 5V . Sketch the citcuit . Determine the effect on the output voltage if a 1.0 kohm load is connected to each tap one at time.

Reference no: EM13286031

Questions Cloud

Determine the length of wire you must use to wind the coil : Nichrome wire of cross-sectional radius 0.758 mm is to be used in winding a heating coil. find the length of wire you must use to wind the coil

What is the size and location of the output waist : A Gaussian beam has a waist of 1.0 mm located 20.0 cm away from a thin converging lens of focal length 10.0 cm. If the wavelength of the source is 633 nm, what is the size and location of the output waist.

Find the torsion constant of the wire : For the two conducting balls as described in problem 1, when one ball is attached to a torsion balance the wire is twisted by a torsional angle of 1°. find the torsion constant of the wire

Find the approximate magnitude of the electric field : A rod 50 cm long and 1.0 cm in radius carries a 2.0 microC charge distributed uniformly over its length. Find the approximate magnitude of the electric field

Dtermine the resistance values for a voltage divider : Dtermine the resistancevalues for avoltage divider that must meet the following specifications. The currrent drain under the unload condition is nit to exceed 5mA. The soure voltage is to be 10V and 5V . Sketch the citcuit.

Determine the work performed by the gas during the cycle : In a Carnot cycle, the isothermal expansion of an ideal gas takes place at 400K, determine the work performed by the gas during the cycle

Determine the resistance and capacitance of the section : A conical section of material extends from 2.0 cm = r = 9.0 cm for 0 = (theta) = 30° with (permitivity) = 9.0 and (omega) = 0.020 S/m. Conductive plates are placed at each radial end of the section. Determine the resistance and capacitance of the ..

Find the heading of the plane with respect to the ground : You are on an airplane traveling 30° south of due west at 180.0 m/s with respect to the air. What is the heading of the plane with respect to the ground

Explain three different algebraic methods that can be used : Explain three different algebraic methods that can be used to minimize equations. In your explanation write generalized equations to show how each method is used. Notice the requirement is to explain, don't just write them down.

User Account

All Pages