Draw a cross-section of the specified pavement design

Assignment Help Civil Engineering
Reference no: EM13309598

You are a project engineer for a large road way project. The roadway to be constructed is 3 miles long and 60 feet wide. • The following pavement design specifications have been issued: - Base coarse: 6" DGA - Stabilized base: 4" - Bottom coarse of asphalt: 3" - Top coarse of asphalt: 2" Determine the following information:

a. How many tons of each material is required? Research and make an assumption of a unit weight for each material. Draw a cross-section of the specified pavement design.

b. Assuming 10' wide lanes, and that you cannot work on more than 50% of the roadway at a given time, how many pieces of the following equipment would you consider utilizing? - Material hauling trucks (assume truck can carry 20 tons/load) - Bituminous distributors - Asphalt paving machine (assume 10' wide) - Vibratory rollers (assume 6' wide) - Explain your rationale through illustrations as well as written description.

Reference no: EM13309598

Questions Cloud

Explain the order of the reaction with respect to sucrose : The following data was obtained on the rate of hydrolysis of 17% sucrose in 0.099 M HCl aqueous solutions at 35 C. What is the order of the reaction with respect to sucrose and the value of the rate constant k
The minimum power rating for each resistor : We have a 15-V source and a load that absorbs power and requires a current varying between 0 and 100mA. The voltage across the load must remain between 4.7 and 5.0 V for all values of load current. Design a voltage-divider network to supply th..
What are some benefit of a feistel structure : How would you protect the passwords on your system using some of the mechanisms we have studied? Discuss implementation strategies and explain your decisions.
Explain what other substance(s) found in chocolate bear : What other substance(s) found in chocolate bear(s) a strong structural resemblance to caffeine? Draw the structures of these substances and point out the similarities.
Draw a cross-section of the specified pavement design : The roadway to be constructed is 3 miles long and 60 feet wide. • The following pavement design specifications have been issued: - Base coarse: 6" DGA - Stabilized base: 4" - Bottom coarse of asphalt: 3" - Top coarse of asphalt: 2"
We give sinusoidal voltage across a capacitor the current : When we give sinusoidal voltage across a capacitor the current across it has 90 degree phase lag. Then this means as voltage increases(sine) the current decreases(cosine)[in 1st quadrant]....Whether this indicates capacitor exhibits negative r..
Explain how many ml of 0.450 m naoh are needed to titrate : How many mL of 0.450 M NaOH are needed to titrate 25.0 mL solution of 0.250 M FeCl3 solution? FeCl3 aq + 3NaOH arrow to Fe(OH)3 aq +3NaCl aq
Performance and quality improvement challenges : Performance and quality improvement challenges facing the USA include which of the following?
Find the expression for the new velocity : A point charge +q of mass m, (m,+q) is placed at point P along the x-axis where V_r(infinity) is known. Find the expression for the new velocity at the second point

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine ratio of heat supplied to engine to heat removed

a reversible refrigerator removesm heat from sink at 8c and rejects heat to the atmosphere at 15c the refrigerator is coubled to the outputnof a reversible heat engine which receives heat at 577c and reject to the atmosphere at 15c

  Determine the initial weight and final density of the water

A steel tank hold 120 ft^3 of water at atmospheric pressure(14.7psi and 68.4 degrees f). the water is subjected to a 100 fold increase in pressure. determine the initial weight and final density of the water if the volume decreases by .545 ft ^3.

  Find concentration of salt in stream after discharge point

Assume that the sewer flow and the stream flow are completely mixed, that the salt is a conservative substance (it does not react), and that the system is at steady state.

  Compute the total energy per unit weight

A fluid flowing in a pipe 30cm in diameter has a uniform velocity of 4m/s. The pressure at the center of the pipe is 40KPa, and the elevation of the pipe's centerline above an assumed datum is 4.5m. Compute the total energy per unit weight of the ..

  What runoff volume will show up in nearby stream to baseflow

If a watershed of drainage area 100 mi^2 has abstractions of 2.5 in/hr, what runoff volume will show up in the nearby stream in addition to baseflow for a rainfall of 5-hr duration with an intensity of 4 in/hr

  What is smallest particle size that will be removed in grit

What is the smallest particle size (density 2.65 g/cm3) that will be removed in a horizontal grit chamber 10 m long and 1.0 m deep if the flow rate is 1000 m3/hr. Assume the temperature of the water is 25°C.

  What will temperature rise of lead be if there is no cooling

Consider the steady-flow energy equation applied to the given extrusion process. Since the die is horizontal then there will be no change in potential energy from inlet to outlet. Hence the potential energy terms can be neglected.

  Determine what is the average stream flow in the period

A catchment has an area of 150 ha and a runo /rainfall ratio of 0.40. If due to a 10 cm rainfall over the catchment a stream flow at the catchment outlet lasts for 10 hr, what is the average stream flow in the period

  Determine the elapsed time after removal from the pouch

Consider a DVD To protect sensitive information within the storage medium, a vwery thin film of reactive polymer is embedded within the polycarbonate at a distance of d= 0.5 mm from the surface.

  Draw to scale the expected streakline of the stream

The following wind conditions are expected: V = 10 i - 5 j mph for 0 10 hr. Draw to scale the expected streakline of the stream  for t = 3, 10, and 15 hr.

  Determine the speed of the car when time t is given

The 1.2-Mg mine car is being pulled by winch M mounted on the car. If the winch generates a constant power output of 30 kW, and the car starts from rest, determine the speed of the car when t = 5s.

  Define holographic mobile phones

A young engineer has invented holographic mobile phones and has approached a venture capital company to invest in it. The venture capital company considers the product to be an all or nothing product

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd