User Account

All Pages

Discuss energy storage scheme from a conversion efficiency

Assignment Help Civil Engineering
Reference no: EM13296856

an electrical-generation utility sometimes pump liquid water into an elevated reservoir during periods of low electrical consumption. this water is used to generate electricity during periods when the demand for electricity exceeds the utilities ability to produce electricity. discuss this energy storage scheme from a conversion efficiency perspective as compared to storing a compressed phase changing substance.

Reference no: EM13296856

Questions Cloud

Compute the operating frequency of brand : A certain dog whistle operates at 22.75 kHz, while another (brand X) operates at an unknown frequency. estimate the operating frequency of brand X
Depict the major product that is formed : Draw the major product that is formed when 2-butyne is treated with an excess of hydrogen gas and a platinum catalyst.
Define what is the equilibrium concentration of hi : The decomposition of HI(g) is represented by the equation 2HI(g) H2(g) + I2(g) Kc= 64 at 25°C. If the equilibrium concentrations of H2 and I2 at 400°C are found to be [H2] = 9.3x10-4 M and [I2] = 1.6x10-3 M, what is the equilibrium concentration o..
What coupon rate should the company set on its new bonds : What coupon rate should the company set on its new bonds if it wants them to sell at par? (Do not include the percent sign (%). Enter rounded answer as directed, but do not use the rounded numbers in intermediate calculations. Round your answer to..
Discuss energy storage scheme from a conversion efficiency : an electrical-generation utility sometimes pump liquid water into an elevated reservoir during periods of low electrical consumption. this water is used to generate electricity during periods when the demand for electricity exceeds the utilities a..
Determine the gravitational force on the satellite : A 2260 kg satellite used in a cellular telephone network is in a circular orbit at a height of 710 km above the surface of the earth. What is the gravitational force on the satellite
Calculate the pressure in psignat the bottom of the tank : Assume a hydrostatic condition in a cubic tank with 64ft length, 32ft width and 16ft height. The tank is filled with 15ppg( pounds per gallon) fluid. Calculate the pressure in psignat the bottom of the tank.
What is the actual moment of inertia of the pulley : You have a pulley 13.1 cm in diameter and with a mass of 2.0 kg. You get to wondering whether the pulley is uniform. What is the actual moment of inertia of the pulley
What is the approximate and the exact real rate of interest : Enter rounded answers as directed, but do not use the rounded numbers in intermediate calculations. Round your answers to 2 decimal places (e.g., 32.16).)

Reviews

Write a Review

Civil Engineering Questions & Answers

  Effective thermal capacity in climates

For energy conservation, materials with a high thermal capacity are effective in climates in which the heat flow through the building envelope is:

  Calculate the force

Calculate the force (in Kn) a punch press must exert if it is to punch out a large washer from a strip of 5-mm thick sheet steel with an ultimate shear strength of 400 MPa. The washer dimensions are as follows: hole diameter is 27 mm. outside diam..

  Determine the net rate of flow of linear momentum

Determine the net rate of flow of linear momentum through the control surface.

  Runoff rate into the inlet grate

If the detention storage on the paved section is increasing at the rate of 60 m3/hr, what is the runoff rate into the inlet grate?

  Largest principal stresses and maximum shear stress

The shaft diameter is 100 mm. Calculate the largest principal stresses and maximum shear stress that will occur in the shaft.

  Tape corrections under following conditions

The tape is stretched over three equal spans. Calculate the tape corrections under the following conditions at field, temperature = 85ºF, pull = 18kg, E= 2.109 x 10 6 kg/cm 2

  Spreader beam and hoisted by a crane

The 3.5mg engine is suspended from a 500 kg spreader beam and hoisted by a crane which gives it an acceleration of 4m/s^2 when it has a velocity of 2m/s. determine the force in chains AC and AD during the lift.

  Required height of the roller coaster

Determine the required height h of the roller coaster so that when it is essentially at rest at the crest of the hill it will reach a speed v= 100km/hr when it comes to the bottom.

  Calculating sand shear strength

Estimate the effective friction angle for the sand (assume c' = 0). Calculate the sand's shear strength (τf) on a horizontal plane at depths of the 20 ft and 50 ft.

  At what rate is the diameter increasing

a spherical balloon inflated sos that the volume is increasing at the rate of cubic meter/min. At what rate is the diameter increasing when the diameter is 12 m?

  Existing equal tangent sag curve

An overpass is being built over the PVI of an existing equal tangent sag curve. The sag curve has a 70 mi/h design speed, and G1 = -6%, G2 = +3%.

  Determine the tension in cables ac and ab

The casting has a mass of 3 Mg. Suspended in a vertical position and initially at rest, it is given an upward speed of V mm/s in 0.3s using a crane hook H. Determine the tension in cables AC and AB during this time interval if the acceleration is ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd