Difference between a just in time system and a kanban system

Assignment Help Operation Management

Reference no: EM13216818

In a two page paper discuss JIT as a process of lean production and inventory control. Be sure to discuss the following conditions supported with examples to demonstrate your understanding of these ideas.

Discuss the concept of push versus pull and how they relate to just-in-time.

What is the difference between a just in time system and a Kanban system?

Can just-in-time be implemented without Kanban?

Reference no: EM13216818

Questions Cloud

How to calculate rupture point of a sample : how to calculate rupture point of a sample in four point bending, given dimensions, Young's modulus, Yield strength and I(Moment of inertia area)

Sketch the thermal circuit of the system : Sketch the thermal circuit of the system. Label (using the above symbols) all pertinent nodes and resistances.

Explain what is the purpose of a company''s 10-k : What is the purpose of a company's 10-K? Write a concise summary of three important items learned from reading Ford Motor Companies 2012 10-K.

Determine the magnitude of the initial velocity : determine the magnitude of the initial velocity of the bullet and the magnitude of the force exerted by the bullet on the block.

Difference between a just in time system and a kanban system : Discuss the concept of push versus pull and how they relate to just-in-time and what is the difference between a just in time system and a Kanban system?

Determine the rate of recrystallization : It is known that the kinetics of recrystallization for some alloy obey the Avrami equation, and that the value of n in the exponential is 8.4. If, at some temperature, the fraction of recrystallization is .30 after 100 min, determine the rate of r..

What is the initial temperature of the water : A piston-cylinder device contains 0.005 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 600 kPa. Heat is transferred at constant pressure until the temperature reaches 200°C.

What is the maximum efficiency of the heat engine : What is the work you get out of each kJ of heat extracted from the basin? Repeat for the case that the water is at 100C. Comment on why efficient car engines run so hot.

Explain personality and perception tied to consumer behavior : Motivation, personality, and perception are all tied to consumer behavior in various ways, such as brand personality, emotional motives, and perceptual mapping.

User Account

All Pages