Determine what will be the hydraulic conductivity of the gcl

Assignment Help Civil Engineering
Reference no: EM13297988

a GCL has a hydraulic conductivity of 5.0 x 10^-9a GCL has a hydraulic conductivity of 5.0 x 10^-9 cm/sec when subjected to a confining pressure of 0.44 psi (3Kpa). If this GCL is used as a liner beneath a 55-ft high landfill with a waste unit weight of 45 lb/ft3, what will be the hydraulic conductivity of the GCL at the bottom of the landfill?

Reference no: EM13297988

Questions Cloud

The kluckhohn and strodbeck values dimensions : Select a situation involving people from more than one culture from the international press. You will analyze the situation based on the Kluckhohn and Strodbeck values dimensions.
Important aspect of understanding health care in the u.s : 1.One important aspect of understanding health care in the U.S. involves an analysis of the "Key Indexes of Health and Disease," as they are termed.
State a structural formula of an alkene or alkenes : Draw a structural formula of an alkene or alkenes (if more than one) that undergo acid-catalyzed hydration and without rearrangement give 2-methyl-2-butanol as the MAJOR product
What is the angle alpha : a 142 kg crate is placed on an inclined ramp. When the angle the ramp makes with the horizantal is increased to ALPHA, If the coefficient of static friction between the crate and the ramp is 0.65, what is the angle alpha when the crate just begins t..
Determine what will be the hydraulic conductivity of the gcl : If this GCL is used as a liner beneath a 55-ft high landfill with a waste unit weight of 45 lb/ft3, what will be the hydraulic conductivity of the GCL at the bottom of the landfill
Competition and collaboration) deal with each aspect : Competition and Collaboration) deal with each aspect
Estimate the settlement of 10ft and 5ft square footing : Footings for a structure are to be built beneath a basement slab on a clay soil at a depth of 20 ft below present ground level. The groundwater table is 15ft below the ground surface. The soil void-ratio is about 0.087.
What is the resistance of the resistor across the capacitor : Given that C = 0.22 µF, and the initial plate charge is Q0. What is the resistance of the resistor across the capacitor
What is the maximum column load in kips that could be placed : What is the maximum column load in kips that could be placed on a 4-ft square temporary footing on a sand for which the standard resistance is about N=15 and the water table is at the surface A factor of safety of 2 is to be maintained against bea..

Reviews

Write a Review

 

Civil Engineering Questions & Answers

  What force vector does the angled member apply

The linkage shown is made up of two 3-kg rectangular members (0.4 m by 0.1 m), and is flying through the air. At the instant shown, the vertical member has angular velocity 4 rad/s, and the angled member has angular velocity 1 rad/s.

  Depreciation using straight line-double declining balance

Calculate the depreciation using straight-line, double-declining-balance (DBB), and MACRS (current IRS regulation) methods; and tabulate the depreciation schedule.

  Types of metamorphic foliations

Name three types of metamorphic foliations, and draw a small sketch that shows a situation. Where a metamorphic foliation could cause problems in an excavation.

  Dissolved inorganic carbon sample

The total dissolved inorganic carbon (TIC) of a sample of groundwater is 8.33 mM. The temperature of the aquifer is 15C, the pH is 7.5, and the ionic strength is 0.05 M. What is the H2CO3, HCO3-, CO3 2-, and the partial pressure of CO2? [Use activ..

  Estimate the power required to accelerate a 1350 kg vehicle

The vehicle has a frontal cross -sectional area of 1.9 m^2. The roadway has a straight alignment and a badly patched and broken asphalt surface. assume a drag coefficient of 0.3 and p of air of 1.29 kg/m^3

  Determine total charge for billing period based on rate

A large residence consumes 3705 kWh of electrical energy over a billing period. Determine the total charge for the billing period based on the rate schedule provided. The margin of error is $0.5

  Graph the data from the table on log-log paper using radius

Based on volume of a sphere V=4/3(pi)r^3, create a table of volume vs. radius allowing radius to vary from 2.0 to 10.0 cm in 1 cm increments. Graph the data from the table on log-log paper using radius as the independent variable.

  What are engineering societies based upon the research

What are Engineering Societies based upon the research? List at least 10 discipline specific engineering societies along with their website addresses.

  Deflection of a simple uniformly loaded beam

Determine the deflection of a simple uniformly loaded beam by the Ritz method,using first one term, then two terms, adn finally three terms in a sine series. Why does the coefficient of sin2piex/L vanish?

  Determine the stations and elevations of pvcs and pvis

Using a design speed of 50 mi/h, determine the stations and elevations of PVCs, PVIs, and PVTs of the two vertical curves required to connect the highway segments, as well as the length of the constant grade section (connecting grade is to be as s..

  Determining the compressive strengths

Determine the compressive strengths of the following: A) A 6-in. diameter concrete cylinder that failed at ta test load of 135,000 B) A-3-in. diameter specimen that failed at a test load of 30,000

  What are the important findings

What are the important findings in Austin Road Co. v. OSHRC and Builders Steel Co. v. Marshall? Your response should be approximately 200 - 300 words and include a reference citation for your response.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd