### Determine what were the size of the deposits

Assignment Help Civil Engineering

### Write a Review

#### Determine the force that should be developed in the cable

Determine the force that should be developed in the cable if the saddle keeps the pipe from sagging or deflection at its center. The pipe and fluid within it have a combined weight of 125lb/ft. EI is constant.

#### Find how much power is required to maintain straight flight

A small aircraft with a wing area of 250 ft2 and a weight of 2200 lb has a lift coefficient of 0.4 and a drag coefficient of 0.05. 1) How much power is required to maintain straight and level flight

#### Find the mole fraction and mass fraction of each component

The output takes the form of a series of peaks where each peak corresponds to a component and a peak area (A) is proportional to the moles (n) of the component ( n = kA) in the sample injected in the GC.

#### Design an earthen channel section into sandy soil

An earthen channel will be excavated into sandy soil for which Vmax = 4.0 ft/sec, n = 0.022, and the recommended m = 3. The channel will have a bottom slope of 0.0011 and accommodate a design flow of 303 cfs. Design (size) the channel section.

#### What is expected ground level concentration 2 km downwind

The SO2 emission from a fixed source is 25 g/s. The effective stack height is 60 m, the wind speed is 4 m/s at the top of the stack. Assuming class C stability, what is the expected ground level concentration 2 km downwind

#### Would calcite be over or under-saturated in hot water heater

If log KSO, calcite (CaCO3(s)) = -8.61 at 50 oC, would calcite be over- or under- saturated in a hot water heater at 50 oC if the water was in equilibrium with calcite at 25 oC (log KSO = -8.30) when it entered the house

#### Concentration of moles in the tank solution

HOCL is added to water in a tank as a disinfectant. After equilibrium is reached it is found that the pH of the water in the tank is 8.2 and the gas phase partial pressure is the head space of the tank is 0.2E-7 atm.

#### Calculate the coefficient of consolidation

For the soil and foundation conditions in fig. 1, determine the time required to reach 75% consolidation in the clay given the consolidation test results and determine the coefficient of consolidation

#### What are the concentrations of the reactants and products

If 0.100 mol each of SO2 and NO2 are placed in a 500 mL vessel at this temperature, what are the concentrations of the reactants and products when equilibrium is established for this reaction?

#### What is the minimum required temperture of the boiler

The coal-fired boilder supplies 70 MW to the steam while thermal energy is rejected to a nearby lake whos average temperature is 15 C. What is the minimum required temperture of the boiler to meet the power demands of the city

#### Find the direction of flow

A conical tube of length 8 m fixed vertically with its smaller end upwards. The velocity head and pressure head at upper ends are 1.27 m and 2.50 m respectively. The velocity head and pressure head at lower ends are 0.203 m and 5.407 m respectivel..

#### Determine the minimum number of coins rich man has

According to his will: First give one coin to manager. 1/5th of the remaining to the elder son. Now give one coin to the manager and 1/5th of the remaining to second son and so on.