Determine what is the transistors emitter current

Assignment Help Electrical Engineering
Reference no: EM13227819

1) in a swamped common-emiter BJT amplifier, as shown below, if Vcc =12 V, R1 =8.2 kohm, R2=10 kohm, Rc = 500 ohm, Re= 1 kohm, Vbe = 0.7 V, and B =100, what is the transistor`s emitter current?

2) in the circuit given below if R1 = 220 kohm, R2 = 56 kohm, Rc = 6.8 kohm, Re = 2.2 kohm, B= 180, or 50 kohm, C1 = C2 =10 u F, Ce = 100 u F, and Vcc = 20 V determine the voltage gain AV.

Reference no: EM13227819

Questions Cloud

Compute the signal voltage at the detectors output : 20 SI fibers, 2 km long each, are spliced together for a 40 km link. Each fiber has a loss rate of 1-dB/km and a numerical aperture of 0.24. Each splice adds 0.5 dB of loss. A laser diode has a threshold current of 10 mA and emits at 3 mW/mA rate.
How much should the father deposit at the end of each year : If the fund earns interest at 8.5% per year ,compounded annually ,how much should the father deposit at the end of each year, up through the 17th year ?
Define the ph of a benzoic acid-benzoic buffer that consists : what is the [H3O+] and the pH of a benzoic acid-benzoic buffer that consists of 0.15 M C6H5COOH and .47 M C6H5COONa? (Ka of benzoic acid = 6.3 * 10^-5)
Define are your observation and explanation : What if any experimental evidence do you have that the equilibrium is affected by the addition of concentrated HCL? Explain Are your observation and explanation in A consistent with Le Chatelier's Principle? Explain
Determine what is the transistors emitter current : 1) in a swamped common-emiter BJT amplifier, as shown below, if Vcc =12 V, R1 =8.2 kohm, R2=10 kohm, Rc = 500 ohm, Re= 1 kohm, Vbe = 0.7 V, and B =100, what is the transistor`s emitter current
How many quantization bits must be used to satisfy : An analog signal ranging between 0 and 1 V must be quantized. The midrange quantization errors must be no greater than 0.1V. How many quantization bits must be used to satisfy this requirement
Determine the order quantity and reorder point : Determine the order quantity and reorder point. Determine the annual holding and order costs.
Describe the fact that the free-radical addition : Trifluoroiodomethane, CF3-I, undergoes free radical addition to alkenes. Explain the fact that the free-radical addition of this compound to 2-methyl-2-butene is faster than its addition to 1-pentene.
Discuss how a fast-food restaurant could measure its quality : Discuss how a fast-food restaurant could measure its quality effectiveness using each of the following definitions of quality; product-based, user-based, value-based, manufacturing-base.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Develop a looping program in mips

How would you develop a looping program in MIPS that will take a series of decimal numbers and arrange them in ascending order from smallest to largest. The sequence of nine numbers are: 5, 3, 8, 9, 2, 4, 1, 7, 6, 3, 8

  Explain problem on complex power

Problem on complex power, An electric load operates at 240 volts. The load absorbs an average power of 8Kw at a lagging power factor of 0.8.

  Calculate the nominal full load current of the machine

A 2000kW synchronous motor operates at a three - phase line-to-line voltage of 4kV. It has a synchronous reactance of 4 ohms per phase. Calculate a) The nominal full load current of the machine when the excitation voltage E0 ( line - to-line) is 4k..

  Determine the resistivity of the wire

And how long it will take to reach that temperature assuming no heat lost in the process and comments on your results and may research the properties of nichrom wire to determine the resistivity of the wire

  Explain which parameter of an fm transmission determines

Do either or both of the reasons you gave in part (a) above also apply to a point to point voice link using frequency modulation? c. Which parameter of an FM transmission determines whether it is wideband or narrow band?

  Which of the following statements is correct

Technician B says that the resistance of a copper wire decreases as its length increases. Which of the following statements is correct?

  Explain single phase circuit

Single Phase Circuit, A resistor and a capacitor are connected in series across a 150 V a.c supply. When the frequency is 40 Hz the current is 5 A

  What data type you would use for temperature

Indicate what data type you would use for the following variables: (a) the temperature (b) the number of days in a week (c) the number of days in a year (d) the number of months in a year

  How to design boost converter and inverter parameters

how to design boost converter and inverter parameters?

  Calculate short-circuit current of a three-phase delta-wye

calculate the short-circuit current of a three-phase delta-wye connected transformer if the short circuit occurs between phase A and the neutral at the low voltage side, and the transformer is supplied by a 13 kV line-to-line voltage.

  Does arrangement violate osha standards for fall protection

the worker's safety harness D-ring is attached to a 12-foot shock absorbing lanyard that is securely fastened to the structure at a point 40 feet above ground level. Does this arrangement violate OSHA standards for fall protection? Explain.

  Design a voltage-divider network to supply the load

The voltage across the load must remain between 4.7 and 5.0 V for all values of load current. Design a voltage-divider network to supply the load. You may assume that resistors of any value desired are available.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd