Determine what force p is required to hold the gate in place

Assignment Help Civil Engineering
Reference no: EM13315605

The air above the liquid is under a pressure of 5 psig, and the specific gravity of the liquid in the tank is 0.80. If the rectangular gate is 6 ft wide and if y1 = 1 ft and y2 = 10 ft, what force P is required to hold the gate in place?

Reference no: EM13315605

Questions Cloud

What would be the difference in average annual water : If 100 acres of farmland were developed for urban housing (four houses per acre), what would be the difference in average annual water requirements after the change over
How many years would this supply a city of 100000 people : A reservoir has a capacity of 2.75 million acre-ft. How many years would this supply a city of 100,000 people if evaporation is neglected. Assume a use rate of 180 gpcd.
Differences in the mathematics test scores : A member of the state legislature has expressed concern about the differences in the mathematics test scores of high school freshmen across the state. She asks her research assistant to conduct a study to investigate what factors could account for th..
Calculate the saturated surface-dry bulk specific gravity : the weight of a sample of coarse aggregate was measured under various conditions with the following results: oven-dry weight in air 1076.3 g air-dry weight in air 1083.3 gsaturated-surface-dry weight in air 1089.2 g
Determine what force p is required to hold the gate in place : The air above the liquid is under a pressure of 5 psig, and the specific gravity of the liquid in the tank is 0.80. If the rectangular gate is 6 ft wide and if y1 = 1 ft and y2 = 10 ft, what force P is required to hold the gate in place
Compute gravimetric water content and buoyant unit weight : A sample of clay was obtained from a point below the water table. An oven-drying test performed on this sample resulted in the following data: Mass of can= 10.88 g Mass of can + wet soil = 116.02 g
Impact of it upon employees : Example of potential negative impact of IT upon employees at Pay-Best Example of potential solution with description and reference and provide an example of how Pay-Best could use IT with the organizational response:
Observe this electromagnetic radiation : Platinum exhibits an extremely intense emission line at 214.4 nm. Could the spectroscope that you used in this lab, also be used to observe this electromagnetic radiation?
How much carbon dioxide-co2 will be produced : How much oxygen (mg O2) is required to support the complete oxidation of 500 mg acetate (CH3COOH). How much carbon dioxide (CO2) will be produced

Reviews

Write a Review

Civil Engineering Questions & Answers

  Find the force in each member for a truss not at the ends

Roof trusses such as the one shown are spaced 6 m apart in a long, rectangular building. During the winter, snow loads of up to 1 KN/m^2 (or 1 KPa) accumulate on the central portion of the roof. Find the force in each member for a truss not at the..

  Compute how many grams of water must be added to soil

it has been calculated that the maximum density for the soil will be obtained when the water content reaches 21.5%. Compute how many grams of water must be added to each 1000g of soil( in its natural state) in order to increase the water content 2..

  How to select an appropriate w14 section

A 30 feet column is braced at the mid-section to prevent premature failure. If the maximum load is 380 kips, select an appropriate W14 section, if any, to support the loading conditions.

  Calculate the temperature of flat world that has an albedo

Calculate the temperature of "flat world" that has an albedo of 0.31 and a solar flux of 1370 w/m^2. One side of flat world faces the sun. Ignore energy emitted from the edge of flat world.

  What is the market value of the plants electricity annually

Biomass is increasingly used as a fuel to produce power and heat. A sugarcane-­? processing mill is powered by a biomass power plant with 140 MW of electricity and with 60 MW of heat in the form of steam for sugar extraction from the cane.

  Calculate the concentration of pm in the stack at conditions

A stack (T=550*F and P=750mm Hg) was sampled using EPA Method 5. The total gas volume that flowed through the dry gas meter was 2.785 cubic meters (at T=60*F and P=800mm Hg). The mass of particles collected was 1.50g.

  Show how kh and kow can be used to describe koa

Show how Kh, and Kow can be used to describe Koa. You must show how the concentration units for all equilibrium distribution ratios either cancel or remain to give the final value for Koa. Octonal-air partitioning coefficient (Koa = C(octanol)/C(a..

  Determine what would be the co concentration in the box

A simple way to model air pollution over a city is with a box model that assumes complete mixing and limited capability for the pollution to disperse horizontally or vertically except in the direction of the prevailing winds

  Explain metallurgical balance in mineral processing

Metallurgical balance in mineral processing, Assume 2000 short tons of ore were mined, 200 tones were rejected as waste and the tonnage accepted for metallurgical treatment

  Explain what is the cost breakdown structure

What is the cost breakdown structure(CBS)? What are its purposes? What is included (or excluded)? How does it relate to a work breakdown structure (WBS)?

  Define mechanical engineering dynamics

Important information about Mechanical engineering dynamics, A 3000 lb car rests on a horizontal street out of gas with its brakes locked.

  Determine the amplitude of steady-state deflection

The motor in the unit runs at 300 rpm and produces an unbalanced force of 60 lb at this speed. Neglect weight of the beams and assume 1% viscous deflection in the system; for steel E=30,000 ksi.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd