Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
It is desired to place the poles of a second order systemso that the time to the peak of the step response is 0.75 sec andso that the settling time (2% criterion) is 3 sec. Plot therequired pole location in the s plane . What are the requiredvalues of zeta and omega n?
An amplifier with a voltage gain of +40 dB, an input resistance of 10 k ohms and an output resistance of 1 kohm is used to drive a 1 k ohms load. what is the value of Avo. Find the value of the power gain in decibels.
A transformer has 100 turns on the primary (terminals 1-1') and 200 turns on the secondary (terminals 2-2'). A current in the primary causes a magnetic flux, which links all turns of both the primary and the secondary.
To develop contoller as a sequential circuit using minimum number of D flip-flops and the minimum number of external gates. the controller should set the values of the control lines appropriately to drive the combinational logic circuit.
a.) The current in a 75 mH inductor changes uniformly by 200 mA in 0.1 ms. What is the voltage across it b.) Determine the inductance of an air core coil with length 20 cm, 200 turns and a diameter of 2 cm.
write a C program to toggle both PA4 and PA7 of PORTA ON and OFF, with a 1-ms delay after each toggle. Assume that clock frequency is 6.25 MHz. Write inline assembly-language code inside of the delay function.
As speed increases, the lower lamp, L1 lights, then L1 and L2, then, L1, L2, and L3, until all lamps light at the highest speed. Once all the lamps illuminate, no further increase in speed will have any effect on the display.
The transfer function of a particular active low pass filter is G(s) = 200/[s(1+0.4s)(1+0.1s)]. a) At a frequency of 1.0Hz it is determined that the gain of this filter in dB b) Find the phase shift in degrees through the filter as the frequency appr..
Write a C-Program that tells whether or not there are repeated cards amoung a 2-d array[4][13]. It returns "true" if it does. The program needs a function to determine whether or not it has repeated cards.
Assuming the op amp is not saturated, find the Thevenin resistance between terminals (a,b). Since there is no independent voltage or current supply, the Thevenin voltage is zero, and one must attach a test source at (a,b)
It is required to use a peak rectifier to design a dc power supply that provides an average dc output voltage of 15 V on which a maximum of 1-V ripple is allowed. The rectifier feeds a load of 150 ohm.
1.Convert 5EDA into binary number. What makes base 16 (Hexadecimal) an attractive numbering systems for representing values in computers 2. What is 4365 - 3412 when these values represent unsigned 12-bit octal numbers
1) What is the difference between Vin and Vo in a voltage clipping circuit with a zener diode 2) Does Vzo of a zener depend on the temperature of the surrpunding 3) Why is it necessary to put a resistor in a voltage regulator cirucit with a zener di..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd