Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The spring loaded supporting rods AB and AC in the figure below aer used as shock absorbers for transporting fragile loads. Knowing that the elastic spring constants for the rods AB and AC are kab = 1.2 kN/m and kac = 1.5 k N/m, respectively determine the unstretched length of each rod after the 30 kg block is removed. Neglect the weight of the rods
Starting from rest, a 4.0-kg body reaches a speed of 8.0 m/s in 2.0 s. What is the net force acting on the body?
A ten-foot high wall will retain a medium dense sand backfill. Determine the Rankine earth pressure diagram and the total active force on the wall.
Using the ADA code, what is the allowable minimum length of the ramp base if base if it is 2 ft high and the code is 1:12
The roadway follows the equation (x^2/(60m)^2) + (y^2/ (40m) ^2) = 1 where x and y are in meters. Find the maximum acceleration experienced by the cars. Hint: begin by making a sketch of the ellipse.
Imagine a slide with a radius of 1.5 m and a vertical drop of 2 m per turn. Further suppose that one of my daughters is sliding down at a constant speed of 2 m/s
The water enters at 1 atm at 10 C and the flow rate through the turbine is 40 m3/s. The water is discharged from the turbine 200 m below the intake at 1 atm and the temperature of the water at the discharge is 10.2 C.
Fluid flows steadily, at a volume rate Q, through a large pipe and then divides into two small pipes, the larger of which has an inside diameter of 25 mm and carries three times the flow of the smaller pipe.
The flow depth and velocity before the jumo are 0.8 m and 7 m/s respectively. The flow depth and velocity after the jump are 2.46 m and 2.28 m/s respectivly. Assuming a flat channel, determine a) the energy loss due to the jump, hl (head loss)
A square yellow-brass bar must not stretch more than 2.5 mm when it is subjected to a tensile load. Knowing that E = 1.5 GPa and that the allowable tensile strength is 150 MPa
Base isolation technique has become the method of choice for structural design of buildings and bridges located in highly seismic areas in recent years.
A plane truss has joint loads P, 2P, and 3P at joints D, C and B, respectively where load variable P=23kN. All members have two end plates which are pin-connected to gusset plates.
Often times, this pressure comes from the fact that community's water supply is stored in an elevated reservoir. Determine how high an elevated reservoir must be so that the water supply has a pressure of 50 psi. Given: the unit weight of water is..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd