Determine the voids and the density of the grains of soil

Assignment Help Civil Engineering
Reference no: EM13306320

An undisturbed saturated soil has a specific weight total of 18.85 kN/m3 and a moisture content of 32.5%. Determine the voids and the density of the grains of soil.

Reference no: EM13306320

Questions Cloud

Create derived subclass called brighteyes : Create derived subclass called BrightEyes for the italicized class code below.
Find the amplitude of the simple harmonic motion : A microphone is attached to a spring that is suspended from the ceiling, as the drawing indicates.  determine the amplitude of the simple harmonic motion
How many clock cycles are needed : Indicate data dependency in the code below. Assuming there is no forwarding in the pipeline, howmany clock cycles are needed to finish the program? If full forwarding is used, how many clock cycles are needed?
Determine the specific weight and total moisture content : A sample of dry sand with a specific gravity total of 16.49 kN/m3 and a relative density of 2.67 grains, is placed outdoors. During a rainy period, the sample volume remains constant but the degree of saturation increases to 40%.
Determine the voids and the density of the grains of soil : An undisturbed saturated soil has a specific weight total of 18.85 kN/m3 and a moisture content of 32.5%. Determine the voids and the density of the grains of soil.
Does standard unix operating system use nondiscretionary : Does the standard Unix operating system use a nondiscretionary access control? Explain your answer.
Determine void ratio-porosity and moisture content of soil : A container containing saturated soils weighs 113.27 g before being placed in an oven and 100.06 g after drying remains in the same container overnight. The empty container weighs 49.31 g and relative density of the grains is 2.80.
Ethics and corporate citizenship : Internet Research AssignmentTwo will concern Ethics and Corporate Citizenship, or lack thereoy
Estimate the electric field at the center of the square : Consider four 8 · µC charges placed at the corners of a square, which is 2.1 ·m on a side. The charges on the top are both positive, Find the electric field at the center of the square

Reviews

Write a Review

Civil Engineering Questions & Answers

  Maximum acceptable tensile service load

Compute the maximum acceptable tensile service load T that may act on a single angle L6x4x3/4 that is welded along only one leg to a gusset plate; thus, there are no holes. The service load is three times the dead load. Solve for a0 A36 steel.

  Determine what is the speed of the ballast bag when it lands

A hot air balloon starting on the ground ascends at a rate of 12 km/hr and is carried by the wind (horizontally) at a rate of 20 kn/h. When the balloon reaches a height of 50 m, a ballast bag is dropped.

  Isotropic and homogenous hydraulic conductivity

Assuming an isotropic and homogenous hydraulic conductivity of 0.0001 cm/s what is the magnitude and direction of specific discharge (q)?

  Find the minimum flow rate of air

Find the minimum flow rate of air and the heat exchanger second-law efficiency.

  What is the so2 concentration caused only by second plant

An existing power plant has been found to produce SO2 concentration of 20µg/m3 at a distance of 800m directly downwind from the stack when the wind is 4m/s from the north during a class C stability situation.

  Determine the axial and hoop stresses at the lower end

Determine the axial and hoop stresses at the lower end of the vessel. A standpipe 12 ft in diameter and 50 ft tall is being con- structed for use as a storage tank for water with a specific weight of 62.4 lb/ft3. The wall thickness of the vessel is..

  Find mu and vu for the beam in a rectangular concrete

The beam is simply supported and spans 25 feet. The beam must be designed for a superimposed uniformly distributed dead load of 1 kip/ft, and a concentrated live load of 12 kips that acts 10 feet from one of the supports.

  Calculate the total axial deformation in the aluminum rods

A rigid rectangular shelf is suspended from a rigid ceiling by mean of four rods of diameter .505 inches. The two rods to the left L1 and L2, are made of steel. The two rods to the right R1 and R2 are made of aluminum.

  Find the increase in vertical stresses due to the weight

The center to center spacing to the two tanks is 14 m. The new tank imparts 150 kPa at the ground surface. Find the increase in vertical stresses due to the weight of the two tanks mid- way between the two tanks at the center of the clay layer.

  Discuss energy storage scheme from a conversion efficiency

an electrical-generation utility sometimes pump liquid water into an elevated reservoir during periods of low electrical consumption. this water is used to generate electricity during periods when the demand for electricity exceeds the utilities a..

  Develop preliminary wbs for small one-story to be construct

The exterior and interior walls are of concrete block. The roof is constructed of bar joists covered with a steel roof deck, rigid insulation, and built-up roofing.

  Compute required weight of coarse aggregate per cubic yard

A concrete mix witha 3-inch slump, w/c rtion of .5, ans sand with a fineness modulus of 2.4 contains 1700 lb/yd^3 of coarse aggregate. compute the required weight of coarse aggregate per cubic yard.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd