Determine the useful power output of the heat engine

Reference no: EM13266471

A Carnot engine uses a steam boiler at 100°C as the high-temperature reservoir. The low-temperature reservoir is the outside environment at 26.0°C. Energy is exhausted to the low-temperature reservoir at a rate of 150 W.

a. Determine the efficiency of the engine.

b. Determine the useful power output of the heat engine.

c. (c) How much steam will it cause to condense in the high-temperature reservoir in 6.00 h?

Reference no: EM13266471

Questions Cloud

Explain what will be the percent relative error : a method for the determination of copper yields results that are too low by 0.47mg. What will be the percent relative error due to this source if the weight copper in a sample is 45.3 mg

Find the change in entropy of the air : A 72.0-kg log falls from a height of 20.0 m into a lake. find the change in entropy of the air during this process

Compute power and the power factor for the total load : The load on a 460-v, 60-Hz, Y-connected, balanced three phase source consists of three equal Y connected impedance of 100-j100 Ohms and three equal delta-connected impedance of 300-j300 Ohms.

State the dry solute and the solvent : How much dry solute would you take to prepare each of the following solutions from the dry solute and the solvent?

Determine the useful power output of the heat engine : A Carnot engine uses a steam boiler at 100°C as the high-temperature reservoir. Determine the useful power output of the heat engine

What is the current of circuit in frequency and time domain : A series circuit has a resistance of 1 ohm and an inductance of 1 ohm. The voltage across the circuit has an amplitude of 15 volts and a phase shift of 30 degrees. What is the current of the circuit in frequency and time domain

Define what is the molar concentration : What is the molar concentration of 2.0 grams of sodium chloride brought to 0.25 L using water

Determine the coefficient of linear expansion : If a material increases it's length from 160m to to 163.20m when it's temperature is raised 160 degrees C, determine the coefficient of linear expansion

Explain how much concentrated solution would take to prepare : How much concentrated solution would you take to prepare 1.25L of 0.120M HNO3 by mixing with water? Nitric acid is usually purchased in a concentrated form that is 70.3% HNO3 by mass and has a density of 1.41 g/mL

User Account

All Pages