Determine the tension in cable cd over the smooth square rod

Assignment Help Civil Engineering
Reference no: EM13305153

Member ABC is supported by cable CD and a square collar at A that fits loosely over the smooth square rod. Determine the tension in cable CD. The smooth rod is fixed at its base and cannot rotate.

Reference no: EM13305153

Questions Cloud

Find the speed of the block after being hit by the bullet : A .005 kg block having a velocity of 500 m/s hits a 5 kg wooden block at rest on a horizontal at an angle of 30 degrees from the horizontal
What diameter of vertical tube would allow mayonnaise : What diameter of vertical tube would allow mayonnaise ( p = 1200 kg/m3) to flow under its own weight
Calculate the heat absorbed during this expansion : an ideal gas expands isothermally,perfoming 5.57x10^3 j of work in the process. calculate the heat absorbed during this expansion
Determine reaction components that ball exert on rod abc : The smooth surface that provides the support at C lies in the y-z plane. Determine the reaction components that the ball and socket exert on rod ABC, the tension in cable BD, and force the smooth wall exerts on end C of rod ABC.
Determine the tension in cable cd over the smooth square rod : Member ABC is supported by cable CD and a square collar at A that fits loosely over the smooth square rod. Determine the tension in cable CD. The smooth rod is fixed at its base and cannot rotate.
Calculate the binding energy per nucleon : A 224Ra atom (Z=88, Atomic mass = 224.020186 amu) consists of protons (Mass = 1.00728 amu), Calculate the binding energy per nucleon
Compute reaction components that hinge a and roller b : The blue plane supporting the roller lis parallel to the xy plane. Force P=600N loads the plate at C. Compute the reaction components that hinge A and roller B exert on the triangular plate.
Determine the linear distance between adjacent maxima : In a double-slit interference experiment, the wavelength is 477 nm, What is the linear distance between adjacent maxima on the screen
Find the energy of the electron in the ground state : Calculate the energy of the electron in the ground state of triple ionized beryllium, which has an atomic number Z = 4

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculating the force in a punch press

Calculate the force (in Kn) a punch press must exert if it is to punch out a large washer from a strip of 5-mm thick sheet steel with an ultimate shear strength of 400 MPa.

  Determine what percent of the hocl is dissociated

A solution of HOCl is prepared in water by adding 15 mg HOCl to a volumetric flask, and adding water to the 1.0 L mark. The final pH is measured to be 7.0. What are the concentrations of HOCl and OCl

  How many resistors out of package of 100 to burn up

A 6.6 mA current is flowing through a 47 kilo-Ohm, 5% tolerance, 2-watt resistor. If the resistor values are uniformly distributed, how many resistors out of a package of 100 would you expect to burn up

  Determine the void content

If the dry-rodded unit weight of an aggregate is 105 lb/ft3 (1680 kg/m3) and its specific gravity is 2.65, determine the void content.

  Maximum rod diameter on lathe machine

If the tensil testing machine can apply no more than 925 lbs. of force to the specimen, calculate the maximum rod diameter that should be used. (precision 0.000)?

  Find the resultant force from all fluids acting on the gate

a tank is filled with oil (specific gravity 0.8) and water to a depth of 10 meter and 6 meter respectively. Find the resultant force from all fluids acting on the gate of 1.8 meter by 9 meter.

  Determine what are air flow and particulate concentration

Three streams of polluted air are combined prior to treatment in an electrostatic precipitator (ESP). The flow and particulate concentration of each stream are 600 cfm at150 mg/m^3, 700 cfm at 200 mg/m^3, and 500 cfm at 1000 mg/m^3.

  Determine what force was needed to buckle the bar

On a very hot day, I saw a 1.6 meter long steel bar held between two rigid supports that had buckled due to the heat. The bar had a cross section of 10 mm by 40 mm, and I assume was A36 steel.

  What fraction of the total ammonia-nitrogen is in volatile

Ammonia is a gas whose smell we detect in manure, cleaning products, and other things. The concentration of this noxious gas can be controlled by regulating the pH of the water because only the non-protonated form, NH3, is volatile.

  What is shear force exerted by oil on m long section of pipe

the flow profile is such that u=u(max)*(1-(r/R)^2) where u is the flow speed and r is the distance from the centre of the pipe in the radial direction. What is the shear stress on the pipe wall What is the shear force exerted by the oil on a 1m lo..

  Prove that the forces are equal and that the lines of action

this cuts it down to a single force that you have to solve for, regardless of what type of member it is. Prove that the forces are equal and that the lines of action are along an angle theta. HINT: Use to do equations of equilibrium.

  What is highest possible final grade in nighttime conditions

An equal-tangent sag curve has its PVI at station 10+00 and elevation at 138 ft. Directly above the PVI the bottom of an overpass structure is at elevation 162 ft. The PVC is at station 4+00. If the initial grade is -4.0%

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd