Determine the temperature rise of the milk shake

Assignment Help Civil Engineering
Reference no: EM13314384

A 45 W electric mixer is operated for 5 minutes while mixing a 2 kg shake. Assume Csubv=4200 J/kg-K for the liquid. Determine the temperature rise (in degrees C) of the milk shake.

Reference no: EM13314384

Questions Cloud

Evaluate the hydrogen ion concentration in a solution : Calculate the hydrogen ion concentration in a solution containing 7.89 g of strontium hydroxide in 600 mL of solution.
Explain what is ka of lactic acid is found in sour milk : Lactic acid, C_3H_6O_3, is found in sour milk. A solution containing 1.00 g NaC_3H_5O_3 in 100.0 mL of 0.0500 M C_3H_6O_3 has a pH = 4.11. What is Ka of lactic acid
Research the international business activities : To assess the progress made by the organisation in establishing itself in the market from first planning its entr strategy until now.
What is the total kinetic energy of the disk : A solid uniform disk of mass M = 9 kg and radius R = 29 cm rests with its flat surface on a frictionless table, What is the total kinetic energy of the disk
Determine the temperature rise of the milk shake : A 45 W electric mixer is operated for 5 minutes while mixing a 2 kg shake. Assume Csubv=4200 J/kg-K for the liquid. Determine the temperature rise (in degrees C) of the milk shake.
Calculate what is the horsepower delivered from automobile : The torque output from an automobile engine shaft is 100 ft*lbf at 3600 rpm. What is the horsepower delivered
Explain oxidation of gaseous dihydrogen to aqueous hydrogen : Write a balanced half-reaction describing the oxidation of gaseous dihydrogen to aqueous hydrogen cations.
Define the electric motor as the system and calculate rate : The electrical power supplied to the motor is 90 kW. The motor in turn delivers 100 hp at a speed of 1000 rpm to a hoist arrangement for an elevator. Define the electric motor as the system and calculate the rate of work for the system.
Ability to convey the content of the reading : Ability to convey the content of the reading

Reviews

Write a Review

Civil Engineering Questions & Answers

  How should be the central dip of the cable profile

If a SS concrete beam, prestressed with a force of 2500 kn,effective span = 10m. It carries a load of 40 kN/m, the central dip of the cable profile should be

  Determine the velocity downstream of the rotor

An early NASA/DOE wind turbine consisted of a 125.0-ft diameter, two-bladed horizontal axis rotor. Maximum power was achieved at a wind speed of 19.0 miles/hr.

  Estimate the hourly so2 and particle emissions

what type of SO2 removal device before (in front of) or after (following) the particle collector would you use?

  Dry unit weight of material

A soil borrow material in its natural state in the ground has a unit weight of 118pcf. Its natural water content is 7%. What is the dry unit weight of this material?

  Tensile modulus of elasticity

Calculate the tensile modulus of elasticity for a 10 laminated composite consisting of 62 percent by volume of unidirectional carbon fibers and an epoxy matrix under isostress conditions.

  Derive eq for reaction force associated with conversation

Derive an equation for the reaction force (Rx) associated with conservation of momentum in a straight length of pipe of uniform diameter. Approximate the velocity as steady and uniform at each cross-section, and the fluid as constant density.

  Find the volume of the material using force equilibrium

Your engineering consulting firm has been asked to determine the specific weight of an unknown material. You decide to use the concept of buoyancy to figure this out. So you weigh the material in both air and water.

  Usage rates if the community has a declining growth rate

Determine how many years from now the consumption will reach its design capacity with current usage rates if the community has a declining growth rate.

  How many cubic yards of soil must be excavated from pit

The soil will be excavated from the borrow pit, moistened to increase the water content to 13.5% (assume i will not change the volume of solid mass) and then compacted to a final dry unit weight of 118 pcf.

  Determine what is angular error if the distance to the pole

A 6-ft range pole is set over a station on which a sight is to be made with a the odolite. If the sight is made to the center of the rod 4-ft up from the ground, and the center of the top of the pole is out of plumb 0.12 feet in a direction normal..

  Determine the velocity in horizontal x-y plane

A particle with a mass of 0.5 kg has a velocity of 10 m/s in the x-direction at time t = 0. Forces F1 and F2 act on the particle, and their magnitudes change with time according to the graphical force-time history shown.

  Find the minimum angle for alpha that allows the boxes

Box 1 weighs 284.49N Box 2 weighs 421.83N. The angle between box 2 and the ramp is 37deg. Find the minimum angle for alpha that allows the boxes to remain stationary.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd