Determine the slope angle at which failure would occur

Assignment Help Civil Engineering
Reference no: EM13558995

A cutting 9 m deep is to be excavated in saturated clay of unit weight 19 kN/m3. The design shear strength parameters are cu = 30 kN/ m2 and ?u = 0. A hard stratum underlies the clay at a depth of 11 m below ground level. Using Taylor’s stability coefficients, determine the slope angle at which failure would occur. What is the allowable slope angle if a factor of safety of 1.2 is specified?

Reference no: EM13558995

Questions Cloud

Evaluate the moment of inertia of the merry-go-round : the radius of a park merry-go-round is 2.2m. to start itrotation you warp a rope around it and pull with a force of 260 Nfor 12 s. what is the moment of inertia of the merry-go-round
What is the bs reading feet at tp1 : Then the instrument is moved to the level location 2 between TP1 and BM2. It has been identified that H1 at level location 2 is 165.14 (elevation at TP1=163.15
Find the probability that at least 7 will ride in carpools : Suppose 76% of all commuters ride to work in carpools. if eight workers are randomly selected, find the probability that at least 7 will ride in carpools.
How far do you travel during this in attentive period : If you are driving 108 km/h alonga straight road and you look to the side for 1.0 s, how far do you travel during this in attentive period
Determine the slope angle at which failure would occur : A cutting 9 m deep is to be excavated in saturated clay of unit weight 19 kN/m3. The design shear strength parameters are cu = 30 kN/ m2 and ?u = 0. A hard stratum underlies the clay at a depth of 11 m below ground level.
What are lisas recognized gain or loss : What are Lisa's recognized gain or loss and adjusted basis for the east coast land on 01/04/13 and what are Lisa's recognized gain or loss on 9/01/14 sale
Evaluate the speed at the bottom of the ramp : A student is skateboarding down a ramp that is 6.0m long andinclined at 18 degrees with respect to the horizontal. find the speed at the bottom of the ramp
Plot the variation of vertical stress with depth below centr : For a horizontal curve, the tangent length is 400 feet and the curve length is 789.59 feet the station of the PT=106+89.58, what is the station of PI?
What is the hight of the column of oil : The largest barometer built was an oil-filled barometerconstructed in Leicester, England in 1991. what is the hight of the column of oil

Reviews

Write a Review

Civil Engineering Questions & Answers

  The block w shown in figure below has a mass of 250 kg bar

the block w shown in figure below has a mass of 250 kg. bar ab rests against a smooth verticalnbspwall at end b and is

  How much lime must be added to neutralize the acidformed

A jar test has shown that the optimum dose of ferric chlorideconsumes all of the alkalinity. If the amount of the ferricchloride that is in excess is 10 mg/l, how much lime(Ca(OH)2) in mg/l must be added to neutralize the acidformed.

  Concentration of tracer in the reactor

What is the concentration of tracer in the reactor 1 h after tracer addition is terminated? The reactor had an initial concentration of tracer of 1.0 mg/L when tracer addition commenced.

  Determine what is the length of the horizontal curve

a vertical curve on this highway connects +1% and +3% grade and is 420ft long. if a horizontal curve on highway is on a two-lane section with 12 ft lanes and has a central angle of 37 degrees and a superelevation of 6%, what is the length of the h..

  What are critical depth and normal depth at given discharge

a low broad crest weir is installed in a wide, rectangular channel to reduce the flow velocity. the channel is 60ft wide, the channel slope is 1 to 2000. Manning's roughness coefficient n=0.014. the discharge per unit channel width is q=60 cfs/ft.

  Determine the maximum negative moment in each span

determine the maximum negative moment in each span and maximum negative moment at each support. remember that live loads shall be placed so as to cause the greatest effect. specify the method that you used to determine the moments.

  Determine the 2-year peak discharge prior to development

A development is being planned within a 250-acre watershed. The present land use is 120 acres of pasture, with soil type B(CN=61), and the rest soil type D (CN=80). The Tc is 54 min. and the 2-year, 24-hour storm depth is 4 in.

  How to determine the npv and the profitability index

A four year financial project has net cash flows of $20,000; $25,000; $30,000; and $50,000 in the next four years. It will cost $75,000 to implement the project. If required rate of return is 20%, conduct a discounted cashflow calculation

  Determine the rate of change of temperature observed by the

A bicyclist leaves from her home at 9 am and rides to a beach 40 mi away. Because of a breeze off the ocean, the temperature at the beach remains 60 °F throughout the day. At the cyclist's home the temperature increases linearly with time, going from..

  What is shear rate in water in sliding and standing plates

What is the shear rate in the water between a sliding and standing plate, if V = 10 ft/s is the moving plate velocity and 0.1 in. is the distance between the plates

  Find the average velocity and mass flowrate out of the elbow

If the weight flowrate into the elbow is 47 lbf/s, find the mass flowrate out of the elbow, the volume flowrate in and out of the elbow, and the average velocity in and out of the elbow.

  How long will it take for the concentration to be one-quarte

A batch system is assumed to be first order. The initial concentration is 225 mg/L. If the reaction rate constant is 0.65 hr^-1, how long will it take for the concentration to be one-quarter the starting concentration?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd