Determine the resulting angular velocity of the wheel

Reference no: EM13549274

1.Assume the sample variances to be continuous measurements Find the probability that a random sample of 25 observations, froma normal population with variance ?2=6 will have avariance s^2

a) greater than 9.1

b) between 3.462 and 10.745.

2.A bolt located 50 mm fm he center of an automobile wheel is tightened by applying the couple shown for 0.10 s. Assuming that the wheel is free to rotate and is initially at rest, determine the resulting angular velocity of the wheel. The wheel has a mass of 19 kg and has a radius of gyration of 250 mm.

Reference no: EM13549274

Questions Cloud

Find the change in length in each case : A 1.0-m rigid horizontal support is hung by two cables as shown. One cable is brass and The other cable is high-density polyethylene plastic. At room temperature (21°C), the cables measure 3.50 m vertically. When the temperature drops to 15°C

Match each transformation description below with the name : Match each transformation description below with the name of a corresponding transformation. Diffusion-dependent with change(s) in phase composition(s) Diffusionless Diffusion-dependent with non change(s) in phase composition(s) The things you match ..

Dry compressed air enters the heat exchanger at 70 degrees : Gaseous oxygen (99% pure, molar basis) is to be produced at a rate of 350ft^3/hr in a Linde single column plant. The column operates at a pressure of 1 atm. Air leaves the compressor at a pressure of 10 atm.

What is the minimum required heat transfer rate from the : A waste heat source is available at 400°C. A heat engine operates using heat from this source. It rejects heat to the surroundings at 38°C. The power from the engine runs an air conditioner to keep the air inside a building at 25°C

Determine the resulting angular velocity of the wheel : Assume the sample variances to be continuous measurements Find the probability that a random sample of 25 observations, froma normal population with variance ?2=6 will have avariance s^2 a) greater than 9.1 b) between 3.462 and 10.745.

Locate the mass center of the assembly : The two upper lengths of the welded Y-shaped assembly of uniform slender rods have a mass per unit length of 0.3 kg/m, while the lower length has a mass of 0.7 kg/m. Locate the mass center of the assembly. lenghts of all rods aew 30mm

Determine the final temperature of the steam and the amount : An insulated piston cylinder device initially contains 0.01m^3 of steam at 473 K the force on the piston is such that it maintains a constant pressure of 400kpa Inside . A valve is now opened and steam at 1Mpa at 473 K is allowed to enter the cylinde..

Determine the system curve for the pump system : Water is pumped from the tank 1 to tank 2 as shown below. The suction side pipe is nominal 4, schedule 40, 24 ft long, f = 0.018, and the discharge pipe is nominal 3 ½ , schedule 40, f = 0.019, and is 400 ft long

Properties must be the same throughout the system : The interaction that occurs between a system and its surroundings as the system executes a process, which is the result of the system being at a temperature different from that of the surroundings.

User Account

All Pages