Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
velocities in a 200-mm-diameter circular conduit, measured at radii of 0,36,64, and 87 mm were 7.0, 6.8, 6.1, and 5.0 m/s, respectively. Find the approximate values (graphically) of the volume flow rate and the mean velocity. Also determine the ratio of the mean velocity to the maximum velocity.
The velocity distribution for water (20 C) near a wall is given by u=a(y/b)^1/6 where a=10m/s, b=2mm, and y is the distance from the wall in mm. Determine the shear stress in the water at y=1mm. [viscosity of water at 20 C = 1.81 x 10^-5]
A 1.5 m diameter culver (concrete barrel, well - rounded entrance) that is 20m long is installed on a slope of 2 percent. The design discharge is 9.5 m^3/sec and the inlet will be submerged but not the outlet.
If bod5 and ultimate bod of a municipal wastewater are 200mg/l and 457 mg/l respectively what is the reaction rate constant? a) .265 b) .050 c) .115 d) .165
The magnetic north azimuth of a line is 128 degrees 27' while the magnetic declination is 3 degrees 30'E. What is the astronomic azimuth of the line (in decimal degrees)?
Determine the total crop water requirement including the leaching ratio of a corn crop with a ECt of 1.7mmhos cm-1 if the ECiw of the irrigation water and precipitation is 5 and 0 mmhos cm-1 respectively
For the soil and foundation conditions in fig. 1, determine the time required to reach 75% consolidation in the clay given the consolidation test results and determine the coefficient of consolidation
A 0.3-m diameter pipeline terminates in a nozzle of outlet diameter = 0.15 m. When water flows through this pipe at a rate of 0.25 m3/s, the force required to hold the pipe (N) is most nearly.
What is the ratio of the magnitude of E2 to the magnitude of E1? You may neglect the effects of gravity on the proton.
What difference does the tightening of bolt in the friction grip joint make to the load at first slip and the failure load.
A vertical curve is to connect two tangents that intersect at station 50+00 and the elevation 500.00ft. The back tangent gradient is -4 percent, the forward tangent gradient is 2 percent, and the elevation of the curve at station 48+50 must equal ..
Assume the only products are CO2, H2O, CO and N2. State results as the CO molar fraction of both wet and dry exhaust products ( wet exhaust products include H2) and dry exhaust products exclude it).
A horizontal curve was designed for a four-lane highway for adequate SSD. Lane widths are 12 feet, and the superelevation is 0.06 and was set assuming maximum fx.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd