Determine the rate of energy transfer from the air to water

Assignment Help Mechanical Engineering
Reference no: EM13703048

Water enters one stream of an unmixed stream heat exchanger at 20°C and increases in temperature by 10°C. Air enters the second stream on the heat exchanger at 400°C and 5 kg/s. The air temperature at the exit of the heat exchanger is 200°C cooler than at the inlet. There inlet pressure of either stream is 110 kPa and is no change in pressure from inlet to exit of either stream.

a. In which region of the phase diagram is water as it enters the heat exchanger?

b. In which region of the phase diagram is water as it leaves the heat exchanger?

c. What is the change in specific internal energy of the water from the inlet to the exit?

d. Determine the flow rate of water.

e. Determine the rate of energy transfer from the air to the water.

Reference no: EM13703048

Questions Cloud

Determine the density of refrigerant : Determine the density of Refrigerant-12 at 3MPA and 200 degrees celcius by using the principle of corresponding states.
Determine net radioactive heat transfer from each surface : A cylindrical furnace is 0.4 m long and 0.4 m in diameter. The two ends are maintained at 600 K and 700 K with emissivities of 0.6 and 0.7 respectively. The lateral surface has an emissivity of 0.8 and a temperature of 800 K. Determine the net radioa..
Minimum wall thickness of pole after incorporating factor : Erected a new sign welcoming people to the campus. The sign is painted on a rectangle of graphite reinforced epoxy which will not bend and measures 3 ft high and 5 ft wide. This sign is fastened along its 3 ft side to a hollow 2014-T6 aluminium (allo..
Air standard diesel cycle has a compression ratio : An air standard Diesel cycle has a compression ratio of 15, and the heat transferred to the working fluid per cycle is 800 Btu/lbm. At the beginning of the compression process the pressure is 14.7 lb/in^2 and the temperature is 60 F. Determine the pr..
Determine the rate of energy transfer from the air to water : Water enters one stream of an unmixed stream heat exchanger at 20°C and increases in temperature by 10°C. Air enters the second stream on the heat exchanger at 400°C and 5 kg/s. The air temperature at the exit of the heat exchanger is 200°C cooler th..
Determine the shear and moment diagrams : Consider a simply supported beam of length 50ft subjected to a uniformly distributed downward load of 10kips/ft from x=10ft to x=40ft and concentrated downward loads of 100kips at x=10ft and x=40ft.
Average tractive effort exerted by the locomotive : An electric locomotive together with its train has a mass of 200 tonne. The average tractive resistance to motion is 55 N/tonne while starting from rest up a gradient of 1 in 100. Calculate time taken to travel the first 1 km if the average tractive ..
Determine if the entropy change of the system is positive : Consider two ideal gases, A and B that are initially separated. For each of the following processes, the gases are allowed to mix. Determine if the entropy change of the system is positive, negative, or zero. Explain. (a) The process occurs isotherma..
What is the entropy change of the steam : Steam enters a nozzle at 4 MPa and 640°C with a velocity of 20 m/s. This process may be considered reversible and adiabatic. The nozzle exit pressure is 0.1 MPa. (a) Draw a sketch of this process. Include all known information. (b) What is the entro..

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  A steady flow centrifugal compressor is supplied with

a steady flow centrifugal compressor is supplied with saturated water vapor at 15kpa and 500kg of the water is

  Explain what is the amplitude of the response x

In the idealized model attached shown, m = 15 kg, k = 135 N/m, and the viscous damping ratio is 0.15. Assume that an external harmonic force F(t) = 15 cos 4 t acts on the system with F0=15 N and forcing frequency of 4 rad/s.

  If the angular position of the slotted arm oa rotates ccw

pin p is constrained to move along the curve defined by the lemniscate r 4 sin 2theta ft. if the angular position of

  A person weighs 180lbs at sea level the radius of the

a person weighs 180lbs at sea level. the radius of the earth is 3960 mi. what force is exerted on the person by the

  The allowable shearing stress is 15ksi in a steel rod ab

the allowable shearing stress is 15ksi in a steel rod ab and 8ksi in a brass rod bc. knowing that a torque of magnitude

  Knowing that es 200 gpa and ea 70 gpa determine a the

compressive centric forces of 160 kn are applied at both ends of the assembly shown by means of rigid plates. knowing

  There is a heat-pump that takes water from one side of the

a 630000 gallon tank sits empty outside where the temperature is 20 degrees f. the tank is then immediately filled

  Consider an ideal combined cycle with compression ratio of

consider an ideal combined cycle with compression ratio of 71 in which air enters the compressor at 295 k enters the

  A rigid tank has a volume of 006m3 and initially contains a

a rigid tank has a volume of 0.06m3 and initially contains a two-phase liquid-vapour mixture of nbsph2o at a pressure

  Methane ch4 at 25 degree celcius 1 bar enters a furnace

methane ch4 at 25 degree celcius 1 bar enters a furnace operating at steady state and burns completely with 240 of

  Design of a vacuum distillation plant for purification

design of a vacuum distillation plant for purification of glycerin by-product from a biodiesel plant.

  Obtain a plot of the approximate transfer function model

the volume of a hemispherical storage tank as a function of its height is given by vt pirh2t - pi3h3t where r is the

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd