Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
To verify the constant of a particular prism, a straight line ABC is laid out. The EDM instrument is first set up at A, with the following measurements recorded:
The EDM instrument is then set up at B, where distance BC is recorded as 289.595 m. Determine the prism constant.
Items are inspected for flaws by two quality inspectors. If a flaw is present, it will be detected by the first inspector with probability 0.9, and by the second inspector with probability 0.7. Assume the inspectors function independently.
A small hole about 4" in diameter and 6" deep is dug into acompacted layer of a soil embankment. 2.96 lbs of motor oil withGs=0.92 is required to fill the hole.
Given a V-shaped channel with a bottom slope of 0.001, a top width of 12ft, and a depth of 6 ft, determine the velocity of flow. Find the discharge in cfs and m^3/s.
Using EES (or other) software, write a program to determine the apparent gas constant, constant volume specific heat, and internal energy of a mixture of three ideal gases when the mass fractions and other properties of the constituent gases are g..
The joints all lie on radial lines subtending angles of 15° as indicated, and the curved members act as two-force members. Distance R.
Brine flood in a 1.9-in-long and 1.5-in-diameter core plug from the North Sea resulted in a stabilized pressure drop of 46.05 psi. The flood was carried out at 0.05 mL/min with brine viscosity of 0.443 cP.
The spring loaded supporting rods AB and AC in the figure below aer used as shock absorbers for transporting fragile loads. Knowing that the elastic spring constants for the rods AB and AC are kab = 1.2 kN/m and kac = 1.5 k N/m
a 2.50-g sample of a large biomolecule was dissolved in 25.0 g of carbon tetrachloride. the boiling point of this
If 100 acres of farmland were developed for urban housing (four houses per acre), what would be the difference in average annual water requirements after the change over? Assume that the irrigation requirement is 2.5 acre-ft of water for a growing se..
A reservoir discharge into a 60-inch concrete pipe (rough surface) that discharges freely. what is the pressure in the pipe at point A consider friction, but neglect minor losses.
Suppose the goal is to cool a room 6 m × 10 m × 2.5 m. Outdoor air is at 30°C, and it has been determined that 10 air changes per hour supplied to the room at 10°C could provide adequate cooling.
A wood board with a 2in. by 4in. cross section is subjected to a tensile load of 100 lb. Determine the average normal stress and average shear stress developed in the wood fibers that are oriented at 30 degrees with the axis of the board.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd