Determine the pressure difference between a and b

Assignment Help Civil Engineering
Reference no: EM13297826

Fluids A and B ave specific gravities .75 and 1.00 respectively. If the mercury is used as manometer liquid determine the pressure difference between A and B

Reference no: EM13297826

Questions Cloud

What fraction of original rotational kinetic energy is lost : A wheel is rotating freely at angular speed 920 rev/min on a shaft whose rotational inertia is negligible. What fraction of the original rotational kinetic energy is lost
Describe the concentration of hi is present at equilibrium : At a certain temperature, the equilibrium constant, Kc, for this reaction is 53.3. H2(g)+I2(g) 2HI(g) Kc=53.3 At this temperature, 0.800 mol of H2 and 0.800 mol of I2 were placed in a 1.00-L container to react. What concentration of HI is present ..
General fund and governmental activities general journal : Amber city borrowed $1,000,000 secured by a 5-year mortgage note. This cash from the note was used to purchase a building for vehicle and equipment maintenance. Show how these two transactions should be recorded in the General Fund and governmenta..
Find the absolute pressure when the barometer reads : determine the preassure in psi at a depth of 20 ft below the free surface of a body of water and find the absolute pressure when the barometer reads 29.9 inches of mercury.
Determine the pressure difference between a and b : Fluids A and B ave specific gravities .75 and 1.00 respectively. If the mercury is used as manometer liquid determine the pressure difference between A and B
Find the resonance frequency of the ear canal : Find the resonance frequency of the ear canal, Treat it as a half-open pipe of diameter 8 mm and length 26.7 mm
Coding properly is important to your organization-patient : Explain why it is important for the patients and the health of the organization to correctly use and apply insurance, including verification of benefits. Explain why coding properly is important to your organization and the patient.
Find the increase in vertical stresses due to the weight : The center to center spacing to the two tanks is 14 m. The new tank imparts 150 kPa at the ground surface. Find the increase in vertical stresses due to the weight of the two tanks mid- way between the two tanks at the center of the clay layer.
What is the angular position of the wheel : At t = 0, a wheel rotating about a fixed axis at a constant angular acceleration of -0.40 rad/s^2 has an angular velocity of 1.5 rad/s, What is the angular position of the wheel at t = 2.0 s

Reviews

Write a Review

Civil Engineering Questions & Answers

  How far stream of section would expect to find uniform flow

The slope of the channel is .15% and the mannings roughness coefficient is .038. estimate the depth 100m upstream of a section where the flow depth is 2.2m using the standard step method. Approximate how far upstream of this section would you exp..

  What is the concentration of ocl-

HOCL is added to water in a tank as a disinfectant. after equilibrium is reached it is found that the pH of the water in the tank is 8.2 and the gas phase partial pressure is the head space of the tank is 0.2E-7 atm. (not: henry's law constant for..

  Determine the torsional moment in the hollow x-section

A concrete box girder bridge has the rectangular x-section. The box is prismatic and considered thin-walled. It span is L=48m and simply supported at points A,B,C and D. The supports are assume to be able to transfer tensile forces.

  Express samples hardness in meq per l and mg per l of caco3

Hardness is sum of all divalent cations (meaning all species with a positive charge of 2) in a water sample. Magnesium (Mg2+) and calcium (Ca2+) are the most common divalent cations that contribute to hardness.

  Which machine should be chosen using an interest rate

North City must choose between two new snow-removal machines. The SuperBlower has a $70,000 first cost, a 20 year life, and an $8000 salvage value. At the end of 9 years , it will need a major overhaul costing $19,000.

  What is effect of packing factor in self compacting concrete

what is effect of packing factor in self compacting concrete?

  Highest point of the piping system

a) The maximum flow rate that can be achieved without cavitation occurring in the piping system. b) The maximum elevation of the highest point of the piping system to avoid cavitation.

  Depreciation using straight line-double declining balance

Calculate the depreciation using straight-line, double-declining-balance (DBB), and MACRS (current IRS regulation) methods; and tabulate the depreciation schedule.

  Estimate how often it will take more than 75 min to repair

Data from service records show that the time to repair a certain machine is normally distrubuted with a mean of 65 min and a standard deviation of 5 min. Estimate how often it will take more than 75 min to repair a machine.

  Compute the radius of the curve

A simple curve has a central angle of 42degreess. A point Y is located 24m from the vertex and has a perpendicular distance of 3.00m from the back tangent.

  Determine the maximum load p that the member can support

A stainless steel tube with an outside diameter of 65 mm and a wall thickness of 5 mm is used as a compression member. If the axial normal stress in the member must be limited to 180 MPa, determine the maximum load P that the member can support.

  What is bulk modulus of a liquid that has a density increase

What is the bulk modulus of a liquid that has a density increase of 0.02 percent for a pressure increase of 1000 lb/ft^2

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd