Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Consider a Carnot heat-engine cycle executed in a steady-flow system using steam as the working fluid. The cycle has a thermal efficiency of 35%, and steam changes from saturated vapor at 300 C during the heat addition process. If the mass flow rate of the steam is 2kg/s, determine the net power (kw) output of this engine.
A 4000-m 3 /day conventional activated sludge plant has an influent with a BOD5 of 190 mg/L and SS of 225 mg/L. What population would this plant serve?
The road is in good condition and is initially dry, but it becomes wet 160 ft before the stalled car (and stays wet until the car is reached). What is the minimum distance from the stalled car at which the driver could apply the brakes and still s..
Cooling at constant pressure followed by heating at constant volume. Calculate Q, W, change in U, and change in H for each of these processes, and sketch the paths of all processes on a single PV diagram.
A constant head permability test is performed on a soil that is 2 cm X 2 cm square and 2.5 cm long. The head difference applied during the test is 18 cm, and 5 cm^3 is collected over a time of 100 sec.
A rectangular clarifier with a length:width ratio of 3:1 receives a flow of 850m3/day. the clarifiers depth is 4.0m and the detention time of the water inthe clarifier is 2.4 hrs, what are the surface overflow rate and the horizontal flow through ..
in inclined circular gate with water on one side shown in the figure. determine the total resultant force acting on the gate and the total location of center pressure.
The 30-Mg freight car A and 20-Mg freight car are moving towards each other with the velocities of VA= 20km/h and VB=10 km/h. A spring mounted on A has k=3 MN/m Determine the maximum compression of the spring mounted on car A.
Concept of CSTR, A lagoon is to be designed to accommodate an input flow of 0.10 m^3/s of nonconservative pollutant with concentration 30.0mg/L and reaction rate 0.20/day
On a 20 ft cantilever beam, Load W1=200 or W2=500 or both may be applied at the midpoint B or at the end of the beam C. The bending moment induced at th fixed support A, MA, will depend on the magnitude of the loads at B and C.
a concrete dam retaining water has a specific weight of concrete of 23.5kn/m3, what is the factor of safety against sliding & overturning and pressure intensity on the base if coefficient of friction is 0.45.
A 0.25 in diameter copper rod BC is securely attached between two identical 1 in diameter steel rods (AB and CD). Find the load P if the total elongation of the system is measured to be 0.0312 in. Esteel= 29,000ksi, Ecopper=17,000ksi.
Find the discharge flowing over a rectangular sharp crested wire, in GPM, which has a width of 9.9 feet and a discharge coefficient of 3.24, if the head above the crest is 1.74 feet.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd