### Determine the molar concentration of the gas in the solid

Assignment Help Civil Engineering
##### Reference no: EM131034404

Using solubility data of a gas in a solid, explain how you would determine the molar concentration of the gas in the solid at the solid-gas interface at a specified temperature.

### Write a Review

#### Draw a mass balance diagram and estimate the monthly mass

Each month the speedy dry Cleaning company buys 1 barrel (0.160 m^3)of dry cleaning fluid . Ninety percent of the fluid is lost to the atmosphere and 10 percent remains as residue to be disposed of

#### How is nitrate related to tn and tkn

Show that the drinking water standard of 10 mg/L nitrate as nitrogen is equivalent to 45 mg/L nitrate. How is nitrate related to TN and TKN?

#### Notch fracture toughness show your supportin calculations

A Charpy V Notch test was conducted for an ASTM A572 Grade 50 bridge steel. the average values of the test results at four different test temperatires were found to be

#### Determine the distance s that the top hoop should be placed

The barrel has an inner diameter of 4ft. Neglect its wall thickness. Assume that only the hoops resist the water pressure. Note: Water develops pressure in the barrel according to Pascal's Law, p=62.4 lb/ft^2, where z is the depth from the surface..

#### Determine the minimum temperature in the cycle

A reversed brayton cycle operates with air entering the compressor at 1 bar and 7 c and leaving at 4 bars air enters the turbine at 37 c the compressor and the turbine efficients are 84% and 88% respectivelt determine

#### Calculate the critical stressrequired for the propagation of

For a brittle material that has a specific surface energy of 0.26J/m2, and flexural strength and elastic modulus valuesof 76.6 MPa and 64 GPa, respectively, calculate the critical stressrequired for the propagation of a surface crack of length 0.05 m..

#### What volume of cmfr would be required to remove

The CMFT has a 4000 gallon volume. What wastewater flowrate can be treated in this CMFR in order to remove 98% of the BOD5

#### Determine the diameter of commercial steel pipe required

Determine the diameter of commercial steel pipe required to convey a minimum of 300 cfs of water at 60 deg F with a head loss of 1.2 ft per 1000 ft of pipe. Assume pipes are available in the following nominal diameters (inches)

#### Determine does there appear to be any trend in the data

The US EPA has published the following data for the release to the Florida environment of sulfuric acid (H2SO4 ), the most widely used industrial chemical (in millions of pounds).

#### Calculate the resolved shear stress acting on the slip plane

A single crystal of a FCC metal is oriented so that the [001] direction is parallel to an applied stress of 35.0 MPa. Calculate the resolved shear stress acting on the (111) slip plane in the [110], [0-11], [10-1] slip directions.

#### What will be the final chemical composition and weight of

If a tank contains 1000 kg of the dilute acid and the concentrated acid is added at a rate of 100 kg/min, how long will it take to bring dilute acid strength to 75 wt% H2PO4? What will be the final chemical composition and weight of the final mixture..

#### Determine the optimum emise velocity per unit speed

If the aircraft flies at 9000 m standard altitude, make a plot of drag (in N) versus speed (from stall to 240 m/s) and determine the optimum emise velocity (minimum drag per unit speed).