Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1.A 100 kg block rests on the inclined surface for which ?s =0.4.If the coe?cient of static friction between the cord and the ?xed peg at B is ?s =0.25, determine the minimum weight of the bucket that will prevent the block from sliding down the incline.
2.A rectangular channel of 20 f t width and having n = 0.017 carries flow of 800 f t^3/s. Calculate
(a) critical depth
(b) the minimum speci c energy
(c) the speci c energy when depth of flow is 7 f t. What type of flow exists when the depth is (d) 2 f t and (e) 6 f t ?
3.For an iron-carbon alloy of composition 5 wt% Fe, make schematic sketches of the microstructure that would be observed for conditions of very slow cooling at the following temperatures: 1175C, 1145C, and 700C. Label the phases and indicate their compositions (aprox.)
A proposed combined cycle power plant is shown below. A gas turbine engine, the topping cycle, takes air at state 1 (T=300 K, P=100 kPa) and compress it irreversibly (hc=0.87) to state 2.
For the beam and loading shown, write the equation of he shear and bending-moment curves and determine the magnitude and location of the maximum bending moment
a dam project specifies 97 compaction. lab tests on the soil being used indicate that it has anbspmaximum dry density
A sewage treatment works (STW) with 4 single-stage trickling filters has become organically overloaded due to the discharge of a biodegradable industrial effluent to the STW. This is causing effluent to pond on the surface of the filters.
a room is to be maintained at 72 F db. It is estimated that the inside wall surface temperature could be as low as 48 F. What maximum relative and specific humidities can be maintained without condensation on the walls
The rapid sand filter being designed for Laramie has the characteristics show below. Determine the head loss for the clean filter bed in a stratified condition. Depth = 0.75 m
A concrete cylinder of height 8 inches and diameter of 4 inches was tested in the lab. The maximum compressive force was found to be 150,000 lbs and a tensile force of 25000 lbs.
Air flows into the atmosphere from a nozzle and strikes a vertical plate as shown in Fig. P5.28. A horizontal force of 9 N is required to hold the plate in place. Determine the reading on the pressure gage. Assume the flow to be incompressible and fr..
design a horizontal curve for a two-lane road. The road has 12-ft. lanes. Due to expansive excavation, it is determined that a maximum of 34 ft. can be cleared from the road's centerline toward the inside lane to provide for stopping sight distanc..
A sedimentation basin is used to remove suspended solids from a wastewater. The rate of flow of wastewater into the tank is 10 L/s, and the influent concentration of suspended solids is 200 mg/L.
Vehicles arrive at a toll bridge at a rate of 430 veh/hr (the time between arrivals is exponentially distributed) Two toll booths are open and each can process arrivals (collect tolls) at a mean rate of 10 seconds per vehicle
Iron and vanadium both have the BCC crystal structure, and V forms a substitutional solid structure in Fe for concentrations up to approximately 20 wt% V at room temperature.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd