Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
answer the given below question
Consider a 1000-W iron whose base plate is made of 0.5-cm-thick aluminum alloy 2024-T6 (p= 2770 kg/m3 and cp 875 J/kg · °C). The base plate has a surface area of 0.03 m2. Initially, the iron is in thermal equilibrium with the ambient air at 22°C. Assuming 85 percent of the heat generated in the resistance wires is transferred to the plate, determine the minimum time needed for the plate temperature to reach 140°C.
In order to comply with regulations, an iron/steel sinter plant installs an electrostatic precipitator (ESP) to collect 98% of the 10 ?m particles from an air stream flowing at 2 m3/s
For load combination 1.2D + 1.6L, determine the maximum negative moment in each span and maximum negative moment at each support. remember that live loads shall be placed so as to cause the greatest effect.
A police officer stops a speeding driver on saturday nigt and gives hima breathalzer test. the test shows that his estimated blood alcohol content is above .08 g/dl, and this is considered evidence of driving while intoxicated
An automobile has been designed to maintain a constant speed of 55 mph on a +5% grade. The weight of the vehicle when fully loaded is 6000 lbs. What is the total resistance in still air of this vehicle? What would be the resistance on a level road? W..
Conversely, if B is high, the switch labeled B is open, and if B is low, the switch labeled B is closed. The output variable is high if the output voltage is 5 V, and the output variable is low if the output voltage is zero. Write a logic expressi..
For a ternary system, three components are present; temperature is also a variable. What is the maximum number of phases that may be present for a ternary system, assuming that pressure is held constant
Why is it necessary to require such conditions-sand cement ratio, w/c ratio and type of sand. A graded sand is specified for use in the mortar cube test. What would be the likely results if a one-sized sand was used instead of a graded sand.
Test reveal that a normal driver takes about 0.75s before he can react to a situation to avoid a collision. It takes about 3 seconds for a drunk driver to do the same. If such drivers are traveling on a straight road
The vehicle was estimated to hit the light pole at 30 mph. The skid was 650 feet long. How fast was the car traveling before applying the brakes
In a random pattern of eight bits used to test a micro-circuit, each bit is equally likely to be 0 or 1. Assume the values of the bits are independent.
For a same soil, two moist densities and their corresponding degrees of saturation are given in the following table Density (kg/m^3) S(%) 1700 55 1800 70 What is the void ratio (e) and the specific gravity (Gs)?
The soil properties of the clay are Cc = 0.25, Cr = 0.05, gsat = 18 kN/m 3 , for the sand gsat = 18 kN/m 3 , and the water table is 2 m below the soil surface. Determine the settlements when a stress of 100 kPa is applied by the building over an a..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd