Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1.A 2 m diameter semicircular channel made of brickwork is to transport water to a distance of 1.7 km uniformly. If the flow rate is to reach 200 m3/min when the channel is full, determine the minimum elevation difference across the channel.
2.The pressurized tank shown was fabricated by welding strips of plate along a helix forming an angle ? (beta) with a transverse plane as indicated below. Determine the largest value of ? (beta) that can be used if the normal stress perpendicu lar to the weld is not to be larger than 85% of the maximum stress in the tank.
A saturated 100 cm^3 clay sample has a natural water content of30%. It's found that the shrinkage limit occurs when the water content is 19%. If the specific gravity of soil solids is 2.7,
The channel entrance is rounded and smooth (negligible head loss at entrance), and the reservoir water surface is 2.5 m above the bed of the channel at the entrance. hf=0.00019*Q2, where Q (in m3/s) is the discharge in the channel.
The turbidity of the water ranges from 30 to 60 NTU, alkalinity exceeds 100 mg/L, hardness is about 50 mg/L as CaCO3, and the water also contains regulated synthetic organic compounds resulting from industrial discharges.
Discuss some of the impact/ importance of the solutiongenerated and how these solutions have improved over time
A flat-belt idler pulley is molded from polystyrene with a bronze bushing. Knowing that the densities of polystyrene and bronze are 640 kg/m3 and 9100 kg/m 3, respectively, determine the x coordinate of the center of gravity of the pulley.
Detennine (1) the required shaker frequency to cause "resonance" and (2) the dynamic magnification ofresponse compared with static response for that level of damping.
A 1-m diameter cylindrical mass, M, is connected to a 2-m widerectangular gate. The gate is to open when the water level,h, drops below 2.5 m. Determine the required value forM. Negate friction at the gate hinge and the pulley.
A 14-in. square concrete post is 6ft tall and reinforced by nine 3/4" diameter steel rods. Assume that the materials are high-strength concrete and ASTM-A36 structural steel.
The spring loaded supporting rods AB and AC in the figure below aer used as shock absorbers for transporting fragile loads. Knowing that the elastic spring constants for the rods AB and AC are kab = 1.2 kN/m and kac = 1.5 k N/m
Determine the magnitude and the point of application the resultant of the four wind forces (distance right of AB, and distance below BC) when a=1.5ft and b=13ft.
CPM Construction plans to buy a truck for $150,000 and sell it for $15,000 at the end of 5 years. The annual operating cost of the vehicle is $60,000. What is the present value of the truck
An air-water vapor mixture at 0.1 MPa, 35 C and 70% relative humidity occupies a volume of 100 m^3 Determine the humidity ratio, the dew point, the mass of dry air in the volume and the mass of water vapor in the volume.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd