Determine the minimum distance from the channel edge where

Assignment Help Civil Engineering
Reference no: EM13562506

Vehicular access to the Toronto Island Airport now involves the use of a small ferry, capable of carrying about 8 automobiles or an equivalent number of trucks, which operates across the 150 metre wide body of water known as the Western Gap.  Due to significant growth in traffic to the Island Airport, consideration is being given to bridging the channel with a two lane (7.4m) road.  Surveys indicate that, in order to provide adequate clearance for the majority of pleasure craft using the channel, the elevation of the road surface over the entire width of the channel must be 6.0 metres above the existing road surface.  Because there are many large tanker trucks involved, the maximum permissible grade is 3.0%.  For a design speed of 70 km/h, determine the minimum distance from the channel edge where it would be necessary to begin elevating the road.

 

Note:  For this problem use tables on vertical curves (vertical curve design tables)

Reference no: EM13562506

Questions Cloud

What is the deflection on a mercury manometer connected : Crude oil is at 50 degrees f (absolute viscosity=2.8*10^-4 lbf*s/ft^2) is flowing through a 24 inch diameter pipe. A pitot-static tube is used to measure the velocity at the center of the pipe
Determine the void ratio and the porosity : A sample of undisturbed soil has a dry weight of 110 lb and volumen of 1 ft^3. If the specific gravity of the soil solids is 2.65, determine the void ratio and the porosity.
What is the average current drawn by the bus : A trolley bus whose mass is 104 kg takes 10 s toreach a speed of 8 m/s starting from rest. What is the average current drawn by the bus
What is the change in momentum now : Suppose that a billiard ball approaches a rail at a speed of 15 m/s and an angle od 60 degrees but rebounds at a speed of 10 m/s and an angle of 50 degrees. What is the change in momentum now
Determine the minimum distance from the channel edge where : Vehicular access to the Toronto Island Airport now involves the use of a small ferry, capable of carrying about 8 automobiles or an equivalent number of trucks, which operates across the 150 metre wide body of water known as the Western Gap
Determine the magnitude of the forces f1 and f2 : The vertical reactions a supports A and B for the feame are 13 kip and 37 kip, respectively. Determine the magnitude of the forces F1 and F2. Also, determine the horizontal reaction at A.
What is the toll that should be charged if it is desired to : A toll bridge carries 5000 vehicles per day when the toll is $1.50/vehicle. It is estimated that when the toll is increased by 25 cents, the traffic on the bridge will decline by 10% of the current volume.
Calculate the force n exerted by the fixed circular slot and : At the instant when theta=35 degrees the orizontal guide is given a constant upward velocity v0=2 m/s. For the instant calculate the force N exerted by the fixed circular slot and the force P exerted by the horizontal slot on the 0.5 kg pin A.
Obtain the change in length of the rod : An aluminum rod is 16.0 cm longat 20°C and has a mass of 350 g. If 13000 J of energy is added to the rod by heat, what is the change in length of the rod

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine how much area must the heat exchanger have

You have been assigned to design a heat exchanger to cool a gaseous process stream in a chemical plant. The stream flow at 20 kg/s and enters at 431 oK, It has a heat capacity of 3.45 J/g-oC , and needs to be cooled to 402 oK.

  What is the effective vertical pressure due to the weight

The initial velocity of a 15-lb block is given as mv1=15i+15j (ft/s). A force defined by F=250i-250tj (lb) acts on the particle from time t=0 to time t=0.3 s for a total duration of 0.3 s. Determine the particle’s velocity at t=1 s. Neglect friction.

  Determine the flow area

A rectangular concrete channel is 3 m wide and 2 m high. The water 20 deg Celsius in the main channel is 1.5 m deep and is flowing at a rate of 30 m^3/s. determine the flow area, wetted perimeter, and hydraulic radius. is the flow laminar or turbu..

  Determine the critical point

The initial ultimate BOD after mixing of the Bergelmir Riveris 12.0 mg/L. The DO in the Bergelmir River after the wastewaterand river have mixed is at saturation. The river temperature is 10degrees celsius

  How much differential settlement is causing additional stres

How much differential settlement is causing the additional stress of 4,000 psi in girder that is rigudly attached to columns at either end of its 50-ft span. The moment of inertia of the beam is 15,000 in4, and it is a 24-in.-deep beam section.

  What contour intervals will be drawn if a 50ft interval

An area that varies in elevation from 463ft - 634ft is being mapped. What contour intervals will be drawn if a 50ft interval is used? Which lines are emphasized?

  Determine the required size of new schedule 40 steel pipe

Determine the required size of new Schedule 40 steel pipe to carry 0.5 cfs (Q = 0.5 cfs) of water at 160o F with a maximum pressure drop of 10 psi per 1,000 ft.

  What ration of lengths will cause the maximum shear stress

A solid circular shaft AC of total length L=L1+L2 is fixed against rotation at ends A and C and is loaded by a tourqe T_b at joint B. If the diameter of the two segements of the shaft are in ratio d2/d1

  Determine the maximum moment that can be carried

Find the nominal flexural strength from part (d.) to the service capacity from part (c.). e.) Compute the ratio of the flexural strength from part (d) to the service capacity from part (c).

  Explain how to estimate the power output of the arrangement

A hydroelectric facility operates with an elevation difference of 50.0 m with a flow rate of 500 m3/sec. If the rotational speed is 90 rpm, determine the most suitable type of turbine and estimate the power output of the arrangement.

  Determine the magnitude of the resultant r and angle theta

Forces F and P have magnitudes of F=40 lb. and P= 60 lb., Using the paralellogram law, determine the magnitude of the resultant R and the angle theta it makes with the horizontal. The given angle is 40 degrees.

  Calculate the volume of water evaporated in cubic meters

A flow of 4.8 m3/s is to be developed from a 500 km2 watershed. The reservoir is estimated to cover 1,700 ha. The annual rainfall is 97 cm, the annual runoff is 30 cm, and the annual evaporation is 120 cm

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd