Determine the maximum water hammer pressure in pipeline

Assignment Help Civil Engineering
Reference no: EM13310137

An emergency drawdown structure for a reservoir consists of a 1,000 ft long, 1.0 ft (inner) diameter commercial steel pipeline with a wall thickness of 0.5 inches. A gate valve is located at the end of the pipe. If the valve is closed suddenly, determine the maximum water hammer pressure that will develop in the pipeline. The water level in the reservoir is 98.4 ft above the outlet.

Reference no: EM13310137

Questions Cloud

Identify a purpose and audience for your presentation : Create a presentation to outline your proposal for the PC specifications to meet the case study requirements. Identify a purpose and audience for your presentation (i.e., are you informing a friend, presenting to the CIO, educating your colleague..
Find the water depth must be three-quarters of the width : A channel of a rectangular section is to take a certain discharge Q at critical flow; prove that for the wetted perimeter, P=b+2y to be minimum, the water depth must be three-quarters of the width
What is the departure rate when the queue reaches vehicles : The arrival rate at a parking lot is 6 veh/ min. Vehicles start arriving at 6: 00 P. M., and when the queue reaches 36 vehicles, service begins. If company policy is that total vehicle delay should be equal to 500 veh-min, what is the departure ra..
What is the deflection on a mercury manometer connected : A pitot-static tube is used to measure the velocity at the center of the pipe. If the fluid velocity is 10 ft/s, what is the deflection on a mercury manometer connected to the pitot-static tube
Determine the maximum water hammer pressure in pipeline : A gate valve is located at the end of the pipe. If the valve is closed suddenly, determine the maximum water hammer pressure that will develop in the pipeline. The water level in the reservoir is 98.4 ft above the outlet.
How to estimate the ultimate total settlement : The settlement analysis for a proposed structure indicates that 6cm of settlement will occur in 4 yr and that the ultimate total settlement will be about 25cm. estimate (a) the ultimate total settlement and ..
What is maximum horizontal acceleration before water spills : An open rectangular tank 1m wide and 3m long contains water to a depth of 1m. If the height of the tank sides is 1.5m, what is the maximum horizontal acceleration (along the axis of the tank) than can develop before the water spills
How far is it from the origin : A particle starts from the origin at t=0 with a veolicty of 6.0i m/s and moves in the xy plane with a constant acceleration of (-2.0i+ 4.0j). how far is it from the origin
Obtain the speed of the electrons when they hit the screen : In a television tube, electrons initially at rest are accelerated by a uniform electric field of magnitude 4.8 105 N/C during the first 5.0 cm of the tube's length, Find the speed of the electrons when they hit the screen

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine elevation and stationing of high point pvc and pvt

a 520 ft long equal tangent crest vertical curve connects tangents that intersect at station 340 00 and elevation 1325 ft the initial grade is if 4 and the final grade is 2.5.

  Determine the normal depth using trial and error technique

For a trapezoidal shaped channel (n=0.014 and slope = 0.0002 with a 20-ft bottom width and side slopes of 1:1.5 (V:H), determine the normal depth using trial and error technique for a discharge of 1000 cfs.

  Estimate the pullout length required for each reinforcement

A continuous geogrid having a reinforcement coverage ratio equal to 100 percent. A continuous metallic grid consisting of W4 bars having a diameter equal to 5.7 mm, a distance between longitudinal bars equal to 150 mm, a distance between transvers..

  Find mu and vu for the beam in a rectangular concrete

The beam is simply supported and spans 25 feet. The beam must be designed for a superimposed uniformly distributed dead load of 1 kip/ft, and a concentrated live load of 12 kips that acts 10 feet from one of the supports.

  Determine the stoichiometric oxygen requirement for fuel

Determine the Stoichiometric oxygen requirement (pounds of oxygen per pound of fuel) for a fuel containing by weight 50% n-octane,25% 1-heptene and 25% methanol.

  What is interaction force in ferris wheel framework and seat

The pivot of each 120 kg seat on a Ferris wheel travels in a circle with a 10 m radius, and the Ferris wheelrotates witha rotational speed of 0.1 rad/sec. What is the interaction force between the ferris wheel framework and the seat H when angle Q..

  Two immiscible fluids are in contact

Two immiscible fluids are in contact. Fluid I is denser and is also well mixed. The concentration of species a is cao everywhere within this fluid and the temperature in fluid I is held constant at To.

  Find probability that a radndomly selected thermometer reads

assume the readings on thermometers are normally distibuted with a mean of 0C and a standard feviation of 1.00C. Find the probability that a radndomly selected thermometer reads greater than 1.23 and draw a sketch of the region.

  Determine remaining load carrying capacity of cracked beam

a reinforced concrete beam with a section of 12 inches width and 24 inches depth is reinforced with 3no. 9 bars. fc'=5000psi and fy=60000psi. a 2 inch cover is used and the beam has a simply supported span lenght of 15ft.

  Determine what is probability of getting an 8gb flash driver

A manufactory company produces flash drivers and their products include: 1GB (10%), 2GB (10%), 4GB (20%), 8GB (30%), 16GB (20%) and 32GB (10%); in addition, there are four different colors for all the flash drivers

  What is the maximum water-hammer pressure that can occur

Water flows in a 100-m long pipe at 3 m/s. If the water temperature is 20 degrees C, determine the minimum valve-closure time to avoid creating the water-hammer pressures. What is the maximum water-hammer pressure that can occur

  Determine the error n in replacing the sine and the tangent

Determine the % error n in replacing the sine and the tangent of an angle by the value of the angle in radians for angle values 5,10,20 degrees. Explain the qualitative difference between the sine and tangent results.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd