Determine the maximum tensil and compressive stresses in sec

Assignment Help Civil Engineering
Reference no: EM13559325

1.If the resultant force is directed along the boom from point A towards O, determine the values of x and z for the coordinates of point C. Set F sub B equal to 1490 N and F sub C equal to 2320 N.

2.The vertical portion of the press shown below consists of rectangle tube of wall thickness t=8mm. knowing that the press has been tightened on wooden planks being glues together until P = 20 kN, determine the maximum tensil and compressive stresses in section a-a.

Reference no: EM13559325

Questions Cloud

What is the depth of the water in the box : a hollow cubical box is 0.30m on an edge. This box is floatingin a lake with one-third of its height beneath the surface. What is the depth of the water in the box
Find the net gain or loss in storage and compute the volume : A mean draft of 380,000 m^3/day is produced from a drainage area of 330 km^2. At the flow line, the reservoir is estimated to cover about 1600 hectares. The annual rainfall is 96.5 cm, the mean annual runoff is 22.8 cm
What is the degree of saturation of the field sample : Let us pretend you are an earthwork construction control inspector and you are checking the field compaction of a layer of soil. After compaction in the field, the density of soil was checked by excavating part of the compacted soil; the volume of so..
Compute the saturated unit weight of the silt using basic : Compute and plot (or clearly sketch) the vertical effective stress distribution up to a depth of 34 ft of silt deposit before the lowering of the water table.
Determine the maximum tensil and compressive stresses in sec : The vertical portion of the press shown below consists of rectangle tube of wall thickness t=8mm. knowing that the press has been tightened on wooden planks being glues together until P = 20 kN, determine the maximum tensil and compressive stresses i..
What is the increase in the surface area of the cube : The length of each edge of an aluminum cube is 0.068 m. Thecube is heated to 152°C from 25°C. What is the increase in the surface area of the cube
Calculate how many beats per second are heard : Two identical mandolin strings under 200 N of tension aresounding tones with frequencies of 523 Hz. How many beats per second are heard
Obtain the volume percentage of ethylene glycol in solution : An antifreeze solution is made by mixing ethylene glycol(p=1116 kg/m3) with water. obtain the volume percentage of ethylene glycol in the solution
Find the spheres electric potential before the discharge : An energy of 39 joules is stored in a metal sphere. If a sparkcarrying 3 x 10-4 C discharges the metal sphere, find the sphere's electric potential before the discharge

Reviews

Write a Review

Civil Engineering Questions & Answers

  Find what flow of water in gallons per second is required

The volume of water in a reservoir is often expressed using the unit of acre-foot. A volume of 1 acre-foot is the amount of water covering an area of 1 acre to a depth of 1 foot. Lake Mead is the largest man-made lake in the United States.

  Explain how to estimate the flow rate of water

the pressure drop over 15 m of 2-cm diameter galvanized iron pipe is measured to be 60 Pa. If the pipe is horizontal, estimate the flow rate of water. use for water v=10^-6 m^2/s and density of water = 1000kg/m^3

  Determine the rate at which heat must be transferred

A 50-ohm electrical resistor carries a current of 5 amperes. The resistor is maintained at a temperature of 30o C. Determine the rate at which heat must be transferred to the surroundings

  Determine the inlet volumetric flow rate for the ammonia

The magitude of the power input to the compressor is 7,5kW and there is heat tranfser from the compressor to the surroundings at a rate of 0.15kW. Kinetic and potential energy are negligible.

  An old wooden telephone pole with a single cross member was

An old wooden telephone pole with a single cross member was blown off center during a recent storm. To temporarily stabilize the telephone pole, a repair crew has attached a cable from the end of the cross member to an eye-ring stake anchored in the ..

  Find maximum temperature to which the steam in the tank

A rigid tank contains 1 kg of H20 at 100 kPa, x=0.1. Given that the tank can withstand a maximum internal pressure of 2 MPa, determine (a)the maximum temperature to which the steam in the tank can be heated,

  Determine the axial forces in the members of the truss

A cable is attached at A and is connected to the wall. Determine the axial forces in the members of the truss using the Method of Joints and indicate whether they are in tension (T) or compression (C). Be sure to provide complete free body diagram..

  Which compressor should he buy and why

A diver is planning to salvage a Spanish galleon located in 200 feet of water. He plans to use a diving suit that will be supplied with air from a hose (assume this to be amply sized) connected to a compressor that he will locate in his boat on the s..

  Hypothetical velocity distribution in a horizontal channel

The hypothetical velocity distribution in a horizontal, rectangular open channel is V=0.3y (m/s), where V is the velocity at a distance y (m) from the bottom of the channel. If the vertical depth of flow is 2 m and the width of the channel is 4 m,..

  How many moles of water condense per cubic meter of feed gas

Suppose a sample of the 90 °C air is put in a closed variable-volume chamber containing a mirror, and the pressure is raised at constant temperature until a mist forms on the mirror. At what pressure would the mist form

  Calculate the temperature of the air in fahrenheit

The "sea-level adjusted" pressure at the airport was about 30.57 inches of mercury. Assuming the density of air is 1.30 kg/m3 and the gas constant for air is 287. J/(kg K), calculate the temperature of the air in Fahrenheit.

  Plot the drawdown after 4 hours as function of position

a confined aquifer with a transmissivity of 7.0x10^-3 m^2/s and a storativity of 5.0x10^-4 is pumped by two wells 35 m apart. One well is pumped at 7.6 L/s and the other at 15.2 L/s.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd