Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A fi ne-grained soil has 60% clay with LL =220%, PL = 45%, and a natural water content of 6%. A standard Proctor test was carried out in the laboratory and the following data were recorded.
(a) Determine the maximum dry unit weight and optimum water content.
(b) If the desired compaction in the field is 95% of the standard Proctor test results, what values of dry unit weight and water content would you specify? Explain why you select these values.
(c) What field equipment would you specify to compact the soil in the field, and why?
(d) How would you check that the specified dry unit weight and water content are achieved in the field?
Assuming a density of 120/ft^3 for masonry brick work, determine the max height of a brick wall if the allowable compressive stress is limited to 150/in^2 and the brick is a) 4" wide b) 6" wide.
An atrium has a floor area of 30 m by 20 m and is 20 m high. The ceiling ventilation is designed for a fuel area of 30 m2 with an energy release rate of 0.5 MW/m2. The inlet openings are very large. An effective heat conduction coefficient can be ..
All stormwater will drain as sheet flow to the center, flow into a drop inlet, and travel through a pipe system to the nearest stream. The parking lot will be mowed grass (clay soil) with a slope of 2 percent toward the center.
The elevtion of M is 875 . a transit was set at point M and a leveling rod was held vertically at point N. the horizontal cross line of the telescope was inclined so the reading of the horizontal cross line
The project involved rapidly placing 5 m of fill over a large area that applied a stress of 100 kPa to the underlying soil. It was initially expected that after 2 years consolidation would be complete.
Define the term precipitation as used in the unit of hydrology engineering
Suppose that from the past experience a professor knows that the test score of a student taking his final examination is arandom variable with mean 70 and standarddeviation 85
Consider a state with a total water withdrawal of 4.5 bgd in 2000. This was distributed as follows: municipal use 1.0 bgd, industrial use 1.5 bgd, and steam electric cooling 2.0 bgd
The price of oil in 2005 was $67 per barrel. "This priceis still lower than price of in 1981" says a government publication. If inflation has average 3.2% per year from 1981 to2005, what was the price per barrel of oil in 1981?
A circular tube has a wall thickness of 10 mm. It is required to carry a load of 1000 kN with a factor of safety of 2.0. The length of the tube is 4 m. What should be the outside diameter if the load is carried in?:
The town needs a total of 2 mgd. The capacity of well 1 is 5 million gallons per day, and that of well 2 is 10 mgd. Using calculus (hint: calculus with substitution), determine the optimal amount of water that will be drawn from each well if the town..
A biological reactor is used to treat wastewater from a small community (Q = 100,000 gpd). The influent BOD5 concentration to the reactor is 200 mg/L and the required effluent BOD5 concentration is 30 mg/L.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd