Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A W14x68 section of A992, Grade 50 steel, is used as a steel column with a total unbraced height of 12 ft. The column ends are both fixed. Determine the maximum axial LRFD safe load for this column
A rubber ball is inflated to a pressure of 65kpa. At that pressure, the diameter of the ball is 240 mm and the wall thickness is 1.25 mm.The rubber has a modulus of elasticity E of 3.6 MPa and a poisson's ratio of 0.48.
You fill a 2 cubic foot wheelbarrow to the top with aggregate. If the specific gravity of the aggregate is 2.548 and 18% of the aggregate is void spaces, how much does the aggregate in the wheel barrow weigh
A 200ft length of steel wire is to carry a tensile load of 340lb. Find the minimum acceptable wire diameter if the maximum allowable stress in the wire is 30ksi, and the lengh of the wire must not increase by more than 2 inches when there is no ch..
A piece of rock weighs 301 N in air and has an apparent weight of 202 N when suspended under water. What are the volume and density of the rock
A 32000 lb airplane lands on an aircraft carrier and is caught by an arresting cable. The cable is inextensible and is paid out at A and B from mechanisms located below deck and consisting of pistons moving in long oil-filled cylinders.
What is the length of a 200 ft. steel tape having a cross-sectional area of 0.004in2 and a modulus of elasticity of 30,000,000 lb/in2 that is standardized at a tension of 20 lb and a temperature of 68°F
two strips of a plastics material are bonded together as shown. The average shearing stress in the glue must be limited to 1000 kpa. what length L of splice plate is needed if the axial load carried by the joint is 55 kN and the width (W) is 315 m..
The column is constructed from high-strength concrete and four A-36 steel reinforcing rods. If it is subjected to an axial force of 37.5 kN , determine the required diameter of each rod so that one-fourth of the load is carried by the concrete
One can lease a car for $550 per month with no down payment or purchase one for $20,000 now. If the nominal interest rate is 8% per year, how many months of use necessary for the two to break even
The mass of each pulley of the system is 50 kg, and mass of the suspended object A is 160 kg. Determine the force necessary for the system to be in equilibrium? Be sure to draw complete free body diagram(s) for full credit.
a wheel barrow is used to lift a 200lb load. the lenght from the wheel axle to the center of the load is 2ft. the length from the wheel and axle to the effort is 5 ft. illustrate and annotate the lever system.
The distance covered by an aerial photograph is determined by both the focal length of the camera and the tilt of the camera. Although the tilt is usually small, both archaeological and Canadian photographs often use larger tilts.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd