Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
answer the following question given below
A 0.3-m3 rigid vessel initially contains saturated liquid- vapor mixture of water at 150°C. The water is now heated until it reaches the critical state. Determine the mass of the liquid water and the volume occupied by the liquid at the initial state.
Workers plan to apply a reflective coating of paint to one surface of an equilateral triangular shaped highway sign. How many square inches of coating need to be applied to the sign if one side of the triangle is 12 inches?
The symmetrical beam shown is made of a material for which the allowable stress is 40 MPa in tension and 100 MPa in compression. Locate its centroid. Calculate the centroidal moment of inertia that will resist the bending moment.
A completely mixed retention basin is used to treat an industrial waste water consisting of a non-conservative pollutant, using a reaction that destroys the pollutant according to first-order reaction kinetics, with k = 0.216/day
The azimuth from station A of a link traverse to an azimuth mark is 212o 12' 36". The azimuth from the last station of the traverse to an azimuth mark is 192o 12' 15". Angles to the right are observed at each station
To float a 160 pound man using helium balloons (assume 0.52 cubic feet per inflated balloon). How many balloons would it take. Assume density of air is 1.29 kg/cubic meter and the density of helium is 0.179 kg/cubic meter.
A town is going to upgrade its primary WWTP to a secondary plant that can meet the effluent standard of 25 mg/L BOD5 and 30 mg/L suspended solids. They have selected a CSTR activated sludge system for the upgrade.
Design a hollow steel shaft with an inside diameter 1/3 that of the outside diameter. The shaft transmits 200 kW at a speed of 20 Hz. The allowable shearing stress is 55 MPa, and the allowable angle of twist is 1 degree per meter of length.
A pump is necessary to lift water from the clear well (reservoir) at a water treatment plant to a storage tower 50-ft high and some distance away. A flow rate of 15 cubic per second (cfs) is required (68F).
A beam of w16 X 50 section has a simple span of 20 ft. The beam is subjected to a uniform load of 2 kips/ft and an axial tensile force of 10 kips. Determine the maximum tensile and compressive stresses in the beam
A loose, uncompacted sand fill is 2 m in depth and has a relative density of 40%. Laboratory tests indicate that the minimum and maximum void ratio of the sand are 0.46 and 0.90, respectively.
The length is 10 feet. What is the nominal strength if Fy=50 ksi. Note that this is a slender-element compression member, and the equations of AISC section E7 must be used
Assume that you have a constant diameter pipe that has no pumps or turbines connected to it.Prove that the fluid in the pipe will flow from a location with high piezometric pressure to one with low piezometric pressure.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd