Determine the length of the crest required

Assignment Help Civil Engineering
Reference no: EM13541232

1.An ungated spillway is to deliver 150,000 cfs with a crestelevation of 1000 ft. The upstream reservoir elevation is not toexceed the elevation of 1030 ft. The streambed is at elevation 800ft. Determine the length of the crest required.

2.A rigid tank contains 5 lbm of water at 60 psia, 320 F. Thetempertaure of the water drops to 260 F as a result of heattransfer to the surroundings Determine:

a. The final pressure in tank

b The mass of the liquid water and vapor water at the finalstate

c Show this process on a p-v diagram w/ respect tothe saturation/actual pressure values etc.

d. The heat transfer

Reference no: EM13541232

Questions Cloud

Consider a disk drive that transfers data in micro-blocks : Consider a disk drive that transfers data in micro-blocks of 5 bytes. There is a probability of bit error, p, for each block transferred (that is, each bit has a probability
Explain what an event list is what it contains : Explain what an event list is, what it contains, and how it is used by event routines. What type of data structure is used to implement an event list?
Describe two ways to test for independence : Will an RNG implemented using a linear congruential generator generate independent values for all lags? Explain your answer.
Give one performance metric of primary interest : Give one performance metric of primary interest to a user of a system and give one performance metric of primary interest to the owner or operator of a system.
Determine the length of the crest required : 1.An ungated spillway is to deliver 150,000 cfs with a crestelevation of 1000 ft. The upstream reservoir elevation is not toexceed the elevation of 1030 ft. The streambed is at elevation 800ft. Determine the length of the crest required.
What is the time elasticity of demand when t=2 minutes : Latent demand for highway travel is defined as the differencebetween the maximum numver of trips that could be made and thenumber of trips that are actually made. given a demandfunction:
A freeway on a level terrain carries a volume : A freeway on a level terrain carries a volume of 4500 veh/hr onfour 11-foot lanes in one direction. the vehicle mix is 75%passenger cars, 10% trucks, 10% buses and 5% recreational vehicles.lateral obstructions are located at a distance of 5 ft on the..
Determine the first-order removal-rate constant : A simply supported beam with a pin support at A and a roller support at B with length L=20 ft has a force P=10 kips applied at x=15 ft from point A. What are the reactions at A?
What are the response variables of interest to performance : Consider a generic PC. What are the response variables of interest to performance? What are the factors (and factor levels) of interest to performance? What are possible workloads of interest? Identify factors (and factor levels) related to both the ..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the maximum possible flame temperature

Consider your cooking gas contains 80% propane and 20% butane. While burning on a cooktop, assume it burns with 200% excess air. If no heat is lost, determine the maximum possible flame temperature.

  Calculate the time required to reduce the level to 1 m

A full tank (3 m height) discharges water from an output pipe following the equation: W_out = A z^1/2. Calculate the time required to reduce the level to 1 m. Data: A _s = 1 m^2, A = 0.2777 kg (s m^1/2), density water = 1000 kg/m^3

  What is the relative humidity for the final mixed parcel

Two parcels of air are mixed. The given properties of the two parcels and the final mixed parcel are as follows: parcel (1): volume = 1 Liter, Temperature = 10 Celsius, pressure = 1 atm, relative humidity = 50%, parcel (2): volume 1 Liter, Tempera..

  Calculate what is the current value of grannys savings

Granny viola has been saving money in the Bread and Butter mutual fund for 15 years . She has been a steady depositor over those years and has a pattern of putting $100 into the account every 3 months.

  Determine the magnitude of the resultant couple forces

friction on the concrete surface creates a couple moment of 100 Mm on the blades of the trowel. Determines the magnitude of the resultant couple forces so that the resultant couple on the trowel is zero

  Determine the required diameter of the shaft

The pulleys attached to the shaft are loaded as shown.  If the bearings at A and B exert only horizontal and vertical forces on the shaft, determine the required diameter of the shaft to the nearest 1/8 in. using the maximum-shear-stress theory of fa..

  Draw a psychrometric diagram labeling the system states

A laboratory space has a heat gain of 3 tons with a sensible heatfactor of 0.7. The indoor design conditions are 78 F at 40% RH. Theoutdoor air design conditions are 95 F at 50% RH. The coolingequipment has a fixed air flow rate of 350 cfm/ton of coo..

  Determine what is the drag coefficient at the cars top speed

A 3000-lb car has a maximum speed (at sea level and on a level, paved surface) of 140 mi/h with 16" radius wheels, a gear reduction of 3.5 to 1, and a drivetrain efficiency of 92%. It is know that at the car's top speed the engine is producing 220..

  Determine the distance corrected for sag with a tension

A distance of 72.55 ft is recorded using a steel tape weighing 0.016 lb per foot. The tapes is supported only at the ends with a tension of 15 lb. Find the distance corrected for sag.

  Find how much should the company be willing to spend

If the systems will reduce insurance claims by $100,000 two years from now, how much should the company be willing to spend now, it is uses an interest rat of 12% per year

  How many days will contractor require to complete the work

A contractor has both a 3-cy and a 5-cy shovel in the equipment fleet. Select the minimum-size shovel that will excavate 400,000 bcy of common earth in a minimum of 130 working days of 8 hr each.

  An unknown immiscible liquid seeps into the bottom of an

An unknown immiscible liquid seeps into the bottom of an openoil tank. Some measurements indicate that the depth of theunkown liquid is 1.5m and the depth of the oil ( specific weight =8.5

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd