Determine the height of the elevator from the bottom of the

Assignment Help Civil Engineering
Reference no: EM13541297

1.A water contains a suspended solids concentration of 10.30 mg/L. Coagulation reduces this to 1.0 mg/L. To accomplish this, an alum dose of 13.30 mg/L is necessary. What is the dry weight of sludge produced in kg/day if the plant treats water at a rate of 1.884 m3/s?

2.A 10 inch steel pipeline 100 feet long carriers 2000 gpm of crude oil. Calculate the head loss when the oil is at a) 80 degree F b) 110 degree F

3.A ball is released from the bottom of an elevator which is travelling upward with a velocity of 2m/s. If the ball strikes the bottom of the elevator shaft in 3s, determine the height of the elevator from the bottom of the shaft at the instant the ball is released.Also find the velocity of the ball when it strikes the bottom of the shaft.

Reference no: EM13541297

Questions Cloud

Calculate the maximum height above roof reached by the rock : A man stands on the roof of a building of height 13.0and throws a rock with a velocity of magnitude 30.0 at an angle of 34.9 above the horizontal. You can ignore air resistance. Calculate the maximum height above the roof reached by the rock.
Consider three ants each clinging for dear life : Consider three ants each clinging for dear life to the top surface of an ordinary compact disc and not moving with respect to the labelling. The ants are at distances 3, 4, and 5 cm away from the axis of rotation of the CD which is spinning at a cons..
What is the equivalent capacitance of the circuit : You have two capacitors: C1=410 nF and C2=260nF and a DC battery (Vbatt=9.00 volts). The two capacitors are connected to the battery in a series.
Determine the smallest allowable value of p if slipping : A recording tape passes over a 20-mm radius drive drum B and under the idler drum C. Knowing that the coefficents of friction between the tape and the drums are us=.40 and uk=0.30 and that drum C is free to rotate, determine the smallest allowable va..
Determine the height of the elevator from the bottom of the : A water contains a suspended solids concentration of 10.30 mg/L. Coagulation reduces this to 1.0 mg/L. To accomplish this, an alum dose of 13.30 mg/L is necessary. What is the dry weight of sludge produced in kg/day if the plant treats water at a rat..
What is the output of the below csim program : What is the output of the below CSIM program?
What is the difference between a combination : Assume that the probability of a server failing over night is p = 0.1. If you have 1000 servers, what is the probability that 100 servers will have failed over night?
What are some additional performance metrics of interest : Suppose you have two systems. System #1 processes jobs at rate 100 jobs/sec and system #2 at a rate 150 jobs/sec. What is the speed-up and relative change of system #1 with respect to system #2?
Describe the experiments needed to evaluate the design : Describe the experiments needed to evaluate the design alternatives. Give both a full factorial design and simple design. These experiments could be conducted on a simulation model or system prototype.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the time interval between air photo exposures

Air photos are taken with specified overlap to take advantage of image parallax. Calculate the time interval between air photo exposures if the ground speed of the aircraft is 160km/h, the focal lenght is 50mm

  Determine the moment of the force about line joining points

the triangular plate ABC is supported by ball and socket joints at B and D and is held in the position shown by cables AE and CF. If the force exerted by cable AE at A is 1000N , determine the moment of the force about line joining points D and B.

  What would be the lightest w shape that can resist a service

A compression member is subjected to service loads of 165 kipsdead load and 535 kips live load. The member is 26 feet long andpinned at each end. Use A992 steel and select a W14shape.

  Determine the 10-year peak discharge that will be required

All stormwater will drain as sheet flow to the center, flow into a drop inlet, and travel through a pipe system to the nearest stream. The parking lot will be mowed grass (clay soil) with a slope of 2 percent toward the center.

  Determine the specific gravity on the sand by a vacuum pump

a cylinder has 500 cm3 of water. after a mass of 100 grams of sand is poured into the cylinder and all air bubbles are removoed by a vacuum pump, the water level rises to 537.5 cm3. Dteremine the specific gravity on the sand

  Calculate the distance between two successive crests

A photograph is taken of a transverse wave travelling along a length of rope. At this instant the shape of the wave is described by y = (2 m) sin ((0.8 rad.m-1)x+0.8 rad). The speed of the wave is 2 m/s. Calculate the distance between two successi..

  Determine what is the full capacity of the sewer

What is the full capacity of the sewer. At what depths of flow in the pipe are the velocities of flow equal to 0.6 m/s. Assume Mannings constant n = 0.013.

  Determine bearing stress in the soil including the weight

A concrete column with cross-sectional area is A= 120inches squared supports an axial compressive load P=9.0 kip, including the weight of the column. Determine the bearing stress in the soil. Concrete weighs 150lb/ft cubed

  Set up the problem and constraints using algebraic symbols

Two factories are manufacturing and supplying a single type of good to four warehouses. The factories can produce a1, and a2 units of the good each month, and the warehouses need b1, b2, b3, and b4 units each month

  Formulate and solve the minimum weight design

consider the cantilever beam-mass system. formulate and solve the minimum weight design.

  Determine the magnitudes of the lift and drag

The forces acting on the sailplane are represented by three vectors. The lift L and drag D are perpendicular. The magnitude of the weight W is 500 lb. If the magnitude of the resultant of the three forces is 0

  What is overall specific gravity of sample initially package

What is the overall specific gravity of a sample initially packaged with a moisture content of 3.5% below the optimum, then saturated (Assume that the soil sample can be compressed fully saturated with water without the occurrence of variation in ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd