Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Determine the height of a radio tower, which appears on a vertical photograph for the following conditions of flying height above the tower base H, distance on the photograph from principal point to tower base rb, and distance from principal point to tower top rt.
(a) H = 2425 ft; rb = 3.18 in.; rt = 3.34 in.
(b) H = 6600 ft; rb = 96.83 mm; rt = 98.07 mm
The in-situ bulk density of the sandy silt is 1.92 Mg/m^3 and its average water content is 13%. determine: a) the total volume of the sandy silt that must be removed from the borrow pit for construction of the embankment
Purpose: To apply techniques learned to the design of a rectangular reinforced concrete beam for moment.
Photogrammetry Question:If you are given the parameters for a 2D affine transformation, DEMONSTRATE how you would determine which parameters are significant.
a 25-ft long crane supported at its lower end by a pin is elevated by a horizontal cable as shown in the figure. a
The aluminum end and the copper end are maintained at temperatures of 50°C and 260°C, respectively. The thermal conductivities of aluminum and copper are 205 and 385 W/m · K, respectively. The temperature of the aluminum-copper junction in the rod..
A square yellow-brass bar must not stretch more than 2.5 mm when it is subjected to a tensile load. Knowing that E = 1.5 GPa and that the allowable tensile strength is 150 MPa
A conical tube of length 8 m fixed vertically with its smaller end upwards. The velocity head and pressure head at upper ends are 1.27 m and 2.50 m respectively.
Pressure loss in the suction pipe work is directly proportional to water veloicty in the pipe work squared, which is inversely proportional to suction pipe work diameter squared.
The coordinates for the benchmark are 1421334.93,783207.62 the first point in the survey for oleson village, is 113.66 feet from the benchmark and at a bearing of n5d27'23"w. this is other survey point 542.16 So how dose this work?
Due to temperature change, a 1/32" hole mismatching occurred. What is the pulling force, in lbs, to be applied for one of the plates to match the two holes The plate length is 3 ft (from the left end to the hole) and its cross section is 1/8" x 1"..
Determine the moment of this force about the bolt center O
Assume that the service station must fill refill the tank with 4.00 m^3 of gasoline once a week.Draw a mass balance diagram and estimate the annual loss of gasoline vapor (in kg/y) for the splash fill method
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd