Determine the force and couple at o equivalent to the two

Assignment Help Civil Engineering
Reference no: EM13543353

1.Why the highest head of the water in the excavation is mathematically guaranteed to occur on the edge of the excavation. explain in mathematical and/or physical.

2.Two forces are applied to the vertical post. Determine the force and couple at O equivalent to the two forces.

3.Head loss and sunshine striking a pipeline cause the temperature of the water flowing inside to rise by 2 degrees Celsius between two measuring points. Find the heat gain in J/N and cal/N.

Reference no: EM13543353

Questions Cloud

Estimate the horizontal force acting on the puck : An air puck of mass m1 = 0.29 kg is tied to a string and allowed to revolve in a circle of radius R = 1.4 m on a frictionless horizontal table. What is the horizontal force acting on the puck
Find the wall friction head loss and the friction force on : Head loss and sunshine striking a pipeline cause the temperature of the water flowing inside to rise by 2 degrees Celsius between two measuring points. Find the heat gain in J/N and cal/N.
How categorizing influences the juvenile justice system : Explain how categorizing influences the juvenile justice system response to juvenile offenders. Be specific and use examples to support your explanation.
Coefficient of rolling friction m for tire under low pressur : Two bicycle tires are set rolling with the same initial speed of 3.50 m/s along a long, straight road, and the distance each travels before its speed is reduced by half is measured. One tire is inflated to a pressure of 40 psi and goes a distance ..
Determine the force and couple at o equivalent to the two : Head loss and sunshine striking a pipeline cause the temperature of the water flowing inside to rise by 2 degrees Celsius between two measuring points. Find the heat gain in J/N and cal/N.
What is the total energy of the comet : What is the potential energy of a comet of mass m around a star of mass M if it is in elliptical orbit that has a pericenter at a distance R and an apocenter at 4R? What is the total energy of the comet?
Find the pressure head at the lower end of the pipe when the : Base course aggregate has a target dry density of 119.7 lb/cu ft in place. It will be laid down and compacted in a rectangular street repair area of 2000 ft*48ft*6in.
Magnetic flux through the wall if the wall faces east : A house has a floor area of 120 m2 and an outside wall that has an area of 31 m2. The earth's magnetic field here has a horizontal component of 2.60 10-5 T that points due north and a vertical component of 5.00 10-5 T that points straight down, to..
Estimate the maximum displacement of the particle : A particle with a mass of 3.5 × 10-20 kg is oscillating with simple harmonic motion with a period of 1.9 × 10-5 s and a maximum speed of 3.9 × 103 m/s. estimate the maximum displacement of the particle

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the velocity of each ball after impact

Two identical pool balls of 57.15 mm diameter may move freely on a pool table. Ball B is at rest and ball A has an initial velocity v=v0i. (a) knowing that b=50 mm and e=0.7, determine the velocity of each ball after impact.

  Estimate probability of observer counting exactly 4-vechile

an observer has determined that the time headways between successive vechile on a section of the highway are exponentially distributed and that 65% of the headways btw vehicles are 9 seconds or greater.

  What is the conversion rate for parts per million by volume

What is the conversion rate for parts per million by volume (ppmv)conversion. How is this converted into atm, Pa, and torr?

  Briefly describe the measures

Briefly describe the measures that should be considered for the control of corrosion of embedded steel in concrete.

  Find the minimum angle for alpha that allows the boxes

Box 1 weighs 284.49N Box 2 weighs 421.83N. The angle between box 2 and the ramp is 37deg. Find the minimum angle for alpha that allows the boxes to remain stationary.

  Compute the do and initial ultimate bod after mixing

The wastewater treatment plant for Pine City discharges 1 × 105 m3/day of treated waste to the Pine River. Immediately upstream of the treatment plant, the Pine River has an ultimate CBOD of 2 mg/L and a flow of 9 × 105 m3/day.

  Compute the unit weight and dry unit weight of solids

a moisture content of 10.2 % and a specific gravity of solids of 2.65. Compute the unit weight, dry unit weight, degree of saturation, void ratio and porosity.

  Determine the angle through which end a of shaft ab rotates

diameter, are connected by the gears shown. Knowing that G=11.2*10^6 psi, determine (a) the angle through which end A of shaft AB rotates, (b) the angle through which end E of shaft EF rotates.

  Define civil and environmental engineering

Civil and Environmental Engineering Question, 1. How is the problem of technology choice related to process selection and product design?

  Find the rate of discharge of water at 60 degrees fahreneit

The 24-in pipe leads from a reservoir (flush entrance), and the 18-in pipe discharges into the air at a point 15 ft lower than the reservoir water surface level. Assuming all changes in section to be abrupt

  Water with a static pressure of 196knm2 flows through an

water with a static pressure of 1.96knm2 flows through an 800 mm diameter pipe. a pitot tube pressure gage in this pipe

  Determine the force at the circular endcap of the pipe

Determine the force at the circular endcap and its location relative to the bottom of the pipe. If there is a hinge at the bottom, what external force would need to be applied to the top to prevent rotation

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd