Determine the flow rate through pipe b

Assignment Help Civil Engineering
Reference no: EM13866730

Q1. A certain part of cast iron piping of a water distribution system involves a parallel section. Both parallel pipes have a diameter of 30 cm, and the flow is fully turbulent. One of the branches (pipe A) is 1000 m long while the other branch (pipe B) is 3000 m long. If the flow rate through pipe A is 0.4 m3/s,

(i) Determine the flow rate through pipe B. Discard minor losses and assume the water temperature to be 150C.

(ii) Show that the flow is fully rough and thus the friction factor is independent of Reynolds number.

409_cast iron piping of a water distribution system.jpg

Q2. The water at 200C in a 10-m-diameter, 2-m-high aboveground swimming pool is to be emptied by unplugging a 5-cm-diameter,  25-m-long horizontal plastic pipe attached to the bottom of the pool. Determine the initial rate of discharge of water through the pipe  and the time (hours) it would take to empty the swimming pool completely assuming the entrance of the pipe is well-rounded with negligible loss. Take the friction factor of the pipe to be 0.022. Using the initial discharge velocity, check if this is a reasonable value for the friction factor.

1520_reasonable value.jpg

Q3 A pump is to be selected for a waterfall in a garden. The water collects in a pond at the bottom, and the elevation difference between the free surface of the pond and the location where the water is discharged is 3 m. The flow rate of water is to be at least 8 L/s.

(i) Select an appropriate motor-pump unit for this job and

(ii) Identify three manufacturers with product model numbers and prices.

(iii) Make a selection and explain why you selected that particular product.

Q4 Write a two page report on the flaps used at the landing and trailing edges of the wings of large commercial aircraft. Discuss how the flaps affect the drag and lift coefficients during takeoff and landing.

Q5 Large commercial airplanes cruise at high altitudes (up to about 40,000 ft) to save fuel. Discuss how flying at high altitudes reduces drag and saves fuel. Also discuss why small planes fly at relatively low altitudes. (Two pages maximum with diagram)

Reference no: EM13866730

Questions Cloud

Who are deaf in relationship to what you have been learning : who are deaf in relationship to what you have been learning about culture?
Transformers dissipation power : To what extant does the transformers dissipation power increase with rising current?
Forces and stress in each member : Determine the forces and stress in each member by using method of joints?
Prepare a description of the agency : Prepare a description of the agency, the population it serves, and the services it provides. Identify the person you are going to interview by title and provide a brief description of this person's duties and/or role in the agency or organization
Determine the flow rate through pipe b : (i) Determine the flow rate through pipe B. Discard minor losses and assume the water temperature to be 150C. (ii) Show that the flow is fully rough and thus the friction factor is independent of Reynolds number.
Methods of investigation- correlational and experimental : Psychological research includes two major methods of investigation: correlational and experimental. In at least 500 words, define these methods, provide an example of a situation where researchers have used each method
Geopolitical event in sri lanka : Geopolitical event in Sri Lanka
Recorded journal entry for the coupon payment on bond : On 6/30/12, a company recorded a journal entry for the coupon payment on its bond. As part of the journal entry, the company debited bonds payable. Which of the following is true regarding this journal entry?
Mortgage is transferred to the corporation : Ester transfers land (basis of $200,000 and fair market value of $355,000) to a controlled corporation in return for stock in the corporation. However, shortly before the transfer, Ester mortgages the land and uses the $25,000 proceeds to meet person..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine force exerts on the path when arrives at point a

A 2-kg block slides on the smooth circular path (Quadrant One of full circle, block moving left to right). If it is released from rest when theta=0 degrees, determine the force it exerts on the path when it arrives at Point A

  Compute the flow rate in the channel in the jump

A hydraulic jump occurs in a rectangular channel 4.0 m wide. The water depth before the jump is 0.4 m and after the jump is 1.7 m. Compute the flow rate in the channel, the critical depth and the headloss in the jump.

  Determine what is the total energy per unit weight

A fluid in an aquifer is 23.6m above a reference datum; the fluid pressure is 4390 N/m2. The fluid density is 0.999E3 kg/m3. What is the total energy per unit mass What is the total energy per unit weight

  Determine the change in storage during 365 days

Evaporation rate in a 3650 acre-lake is 100 acre-ft/d. If inflow to the lake is 25.2 cfs, determine the change in storage (ft) during 365 days.

  Calculate the retardation coefficient for the three chemical

Groundwater has been contaminated with three chemicals: benzene (log Kow 2.13), pentachlorobenzene (log Kow 5.03), and naphthalene (log Kow 3.36). The aquifer (rs = 2.3 g/cm3; h = 0.4; foc = 0.02) has a gradient of 0.004 and hydraulic conductivity..

  Estimate the total water that will be withdrawn in 2015

Consider a state with a total water withdrawal of 4.5 bgd in 2000. This was distributed as follows: municipal use 1.0 bgd, industrial use 1.5 bgd, and steam electric cooling 2.0 bgd

  Compute the average linear velocity in m per s

An aquifer has a hydraulic conductivity of 12 ft/day and an effective porosity of 17% and is under a hydraulic gradient of 0.0055 m/m. A. Compute the specific discharge in m/s.

  Maximum height of its centre of gravity

If a mass of 500kg is placed centrally on the top face of the buoy, find the maximum height of its centre of gravity above the bottom of the buoy so that the buoy may remain in stable equilibrium.

  Find what depth of aggregate is needed at the angle theta

A 2000-lb wheel load is to be supported by aggregate over soil with a maximum bearing pressure of 1000 lb/sqft. What depth of aggregate is needed if the angle theta is 40 degrees

  What is the required detention time and tank volume

A chlorination process is to be used to disinfect a wastewater treatment plant effluent. The plant treats 1.8MGD (million gallon per day). The water entering this unit has about 4500mg/L of coliforms, and the effluent target is 0.1 mg/L of coliforms.

  How does the engineering classification of soils differ from

A sample of undisturbed soil has a dry weight of 10 lb and volumen of 1 ft^3. If the specific gravity of the soil solids is 2.65, determine the void ratio and the porosity.

  What will be degree of saturation of the compacted embanment

An earth embankment is compacted at water contect of 17% to a bulk density of 1.90 gm/cc.If the specific gravity of soil grains is 2.65, then what will be the degree of saturation of the compacted embankment

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd