Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
An adiabatic piston-cylinder device equipped with a spring maintains the pressure inside at at 300kPa when the volume is 0, and 3000kPa when the volume is 5 m3. The device is connected to a steam line maintained at 1500kPa and 200 C, and the initial volume is 0. Determine the final temperature (and quality if appropriate) when valve is opened and steam in the line is allowed to enter the cylinder until the pressure inside matches that in the line. Also determine the total work produced during this adiabatic filling process.
Barron Chemical uses a thermoplastic polymer to enhance the appearance of certain RV panels. The initial cost of one process was $130,000 with annual costs of $49,000 and revenues of $78,000 in year 1, increasing by $1000 per year.
The beam is simply supported and spans 25 feet. The beam must be designed for a superimposed uniformly distributed dead load of 1 kip/ft, and a concentrated live load of 12 kips that acts 10 feet from one of the supports.
Set up a table showing curve elevations at the PVC, at the PVT, and at the half-station points along the curve. Compute the station and elevation of the curve turning point.
A 2000-lb wheel load is to be supported by aggregate over soil with a maximum bearing pressure of 1000 lb/sqft. What depth of aggregate is needed if the angle theta is 40 degrees
If we apply a breaking system to a skateboard while the speed of the skateboard is 5Milies per hour, the rider average weights is 180bounds while his height is 170 cm. You can assume the distance as it is 50meters.
Essentials of Soil Mechanics and Foundations 7th Edition David McCarthy An oil storage tank 50 ft in diameter imposes a maximum loading of 2500 psf onto the ground surface where the tank is supported.
a 150 kg mass is suspended by wires from two hooks. the lengths of the wires have been adjusted so that the wires are each 50º from horizontal. assume that the mass of the wires is negligible.
The investigation results indicated that the clay had a saturated density of 1.6 Mg/m3, an average initial void ratio of 1.8 and the preconsolidation pressure at the mid depth of the clay layer was 20 kPa.
A C10x20 catilever beam is 12 feet long, supported on the right side. The beam supports two point loads: Load 1 is 2500 lbf and is located 2.5 feet from the wall. Load 2 is 1300 lbf and is located 12 feet from the wall.
A pipe line of 1.25 m diameter has a circular gate at its end. This gate can be operated around its horizontal diameter. If the pipe is flowing full with velocity almost equal to zero, calculate the turning moment required to operate the gate
What are the velocities of both just before impact and just after impact. There is a distance of 5m between the vehicles prior to the winch being turned on.
You are assined the task of process design for a fixed-bed carbon adsorber system. You are given the following data: the inlet airstream flows at 5000 acfm (at 95 degrees F and 1 atm) and contains .2% n-pentane by volume
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd