Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1.Deteemine the velocity of the 30 kg block A if the two blocks are released from rest and the 20 kg block B Moves 0.6 mup the incline .The coefficient of kinetic friction between both blocks and the inclined planes is 0.10
2.What is the significance of quality of bentonite slurry in the construction of diaphragm walls?
3.What are the differences in applications between pipe culverts and box culverts?
4.A diffuser receives an ideal gas flow at 100 kPa, 300 K with a velocity of 250 m/s and the exit velocity is 25 m/s. Determine the exit temperature if the gas is argon, helium or nitrogen.
Using the tables in the AISC manual, make a preliminary selection of member size, using a HSS shape. Do not simple state a choice - state your logic step by step, quoting page numbers (AISC) for each step.
The tank has an inside diamater of 100 cm and will be subjected to a maximum internal pressure of 820 kPa. The allowable tensile stress in the wall is 83 MPa, and the allowable tensile stress in the weld is 55 MPa.
A closed box with horizontal base 6m x 6m and height of 2m is half-filled with water and is accelerated Ax=4.9 m/sec^2 and Ay=-2.4 m/sec. find the pressure at the forward and rear corners along the bottom.
Flue gas containing NO2is then treated by an air pollution control equipment with 85% efficiency. Determine the annual emission rate of NO2 leaving the air pollution control device.
You are given the following information about a dry-batchpaving operation. You are going to use one mixer that has a servicerate of 30 serives/hr. The dry-batch trucks you use forbringing concrete to the paver have an arrival rate of 7.5 arrivals/hr...
Does the presence of Mg2+ significantly interfere with the determination of Ca 2+ by the EDTA titration?
The kinetics of the austenite-to-pearlite transformation obey the Avrami relationship. Using the fraction transformed-time data given below, determine the total time required for 95% of the austenite to transform to pearlite
Matt is building a stand made out of mud bricks ( ultimatecompressive strength approximately 100 psi and density 250lbs/cubit foot) in the shape of a tent (triangular sides, verticalfront and back).
Can a contractor claim that liquidated damages should be limited Because of political unrest, only 20% of rooms are occupied. Liquidated damages are set to $30000 per day -> reasonable amount Contractor is late 15 days.
E on roads extending east and west and S on roads extending north and south.Those roads traveling east and west are designated a number and the letter E.
Compute the maximum acceptable tensile service load T that may act on a single angle L6x4x3/4 that is welded along only one leg to a gusset plate; thus, there are no holes. The service load is three times the dead load. Solve for a0 A36 steel.
Design a series of closely spaced parallel box beams that will support an asphalt road surface over a 10 foot wide, 40 foot long span. The hollow box beams are made of concurred and imbedded No. 8 steel rods (1 inch dia.).
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd