Determine the estimated cost of a similar process unit

Assignment Help Civil Engineering
Reference no: EM13555192

1.The water content in one of five standard Proctor test samples is 15.2%. The corresponding degree of of saturation is 85%. Calculate the dry unit weight if Gs=2.67

2.The cost of a 620 ft3/hr process unit is $920,000. From historical cost records, the capacity ratio exponent of a process unit is 0.5. Use the capacity ratios raised to an exponent method to determine the estimated cost of a similar process unit with a capacity of 310 ft3/hr.

Reference no: EM13555192

Questions Cloud

How much water in cubic feet has been pumped out of storage : If the head in the Jordan has been pumped down by 100 ft in recent times, how much water in cubic feet has been pumped out of storage for an area of 100 sq. mi.?
Determine the maximum water table elevation : A canal was constructed running parallel to a river 1500 ft away. Both fully penetrate a sand aquifer with a hydraulic conductivity of 1.2 ft/d. The area is subject to rainfall of 1.8 ft/y and evaporation of 1.3 ft/y. The elevation of water above the..
What is the optimal distance between the two drainage : To avoid the salinization of soil in a farming area, parallel drainage canals are to be installed to maintain the water table at a depth of at least 4m below the ground surface.
Determine the largest angle through which end a can be rotat : The composite shown is to be twisted by applying a torque T at end A. Knowing that the modulus of rigidity is 77 GPa for the steel and 27 GPa for the aluminum, determine the largest angle through
Determine the estimated cost of a similar process unit : The cost of a 620 ft3/hr process unit is $920,000. From historical cost records, the capacity ratio exponent of a process unit is 0.5. Use the capacity ratios raised to an exponent method to determine the estimated cost of a similar process unit with..
What is the probability that it will be found by inspect : Items are inspected for flaws by two quality inspectors. If a flaw is present, it will be detected by the first inspector with probability 0.9, and by the second inspector with probability 0.7. Assume the inspectors function independently.
Assume statistical independence between the concentration : The daily concentration in the air for a given city is normally distributed with a mean of 0.03ppm and c.o.v. of 40%. Assume statistical independence between the concentration for any two days. Suppose the criteria for clean air standard require that..
What is the probability that all eight bits are 1 : In a random pattern of eight bits used to test a micro-circuit, each bit is equally likely to be 0 or 1. Assume the values of the bits are independent.
What proportion of cans contain less than 12oz : The fill volume of cans filled by a certain machine is normally distributed with mean 12.05oz and standard deviation 0.03oz.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what ph results when mole of nah are added

The temperature = 25°C; assume that u = 10^-2 after the addition. Compare the value obtained when ionic strength effects are taken into account with that calculated when it is neglected.

  Find what is the range of the values that would be expected

a spot speed study was conducted on a freeway on which the mean speed and the standard deviation were found to be 72 .4 mi/hr and 5.4 mi/hr, respectively. what is the range of the values that would be expected to contain the middle 95 percent of s..

  Determining a maximum safe speed

The central angle is 35 degrees, the superelevation is 0.08, and 20.6 ft is cleared (for sight distance) from the inside edge of the innermost lane. Determine a maximum safe speed (assuming current design standards) to the nearest 5 mi/h.

  What is the estimated uncertainty in the length of vector

The base line vector between the base and roving reciever is 8340m and has an accuracy of +/-(1to 2 cm +/-2ppm). What is the estimated uncertainty in the length of this vector

  How many days will contractor require to complete the work

A contractor has both a 3-cy and a 5-cy shovel in the equipment fleet. Select the minimum-size shovel that will excavate 400,000 bcy of common earth in a minimum of 130 working days of 8 hr each.

  Find probability that vehicle pulling out will get accident

The driver of the vehicle does not look for oncoming traffic. Road conditions and vehicle speeds on the highway are such that it takes 1.5 seconds for an oncoming vehicle to stop once breaks are applied.

  Water heater that consists of an insulated pipe

It's proposed to have a water heater that consists of an insulated pipe of 5-cm diameter and an electric resistor inside. Cold water at 20oC enters the heating section steadily at a rate of 30L/min

  Calculate the compressive normal stress in the bar

A stainless steel (304) bar with a cross section of 0.2" x 0.4" is cut to a length of 30" and placed between two immovable walls at a  temperature of 40 degrees F. The operating temperature for the bar is 200 degrees F.

  Determine the speed of each disk after the collision and the

Three cylinders from the same mix were tested for strenght.  Cylinders A and B were cast in 4x8 molds while cylinder C was cast in a 6x12 mold.  The total loads were as follows; cylinder A= 65,200 lbs.,  cylinder B= 68,550 lbs., cylinder C= 151,190 l..

  Calculate stress along edge c-d caused by applied force

A horizontal prestressing force of 500kN is applied to a rectangular beam. The beam has a depth of 450mm and a width of 250mm. The force is applied at a distance of 60mm below the sections x-x axis.

  What do they estimate thhe acceleration due to gravity to be

In an experiment to estimate the acceleration due to gravity,a student drops a ball at a distance of 1m above the floor. His labpartner measures the time it takes to fall and obtains an estimateof 0.46s.

  Determine the minimum uniform thickness of concrete

The PVC pipe weighs 36.1 pounds per foot of length. Determine the minimum uniform thickness (in) of concrete (150 lbs/ft^3) required around the exterior of the PVC pipe to prevent the empty pipe from floating.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd