Determine the equilibrium concentrations of the gases

Assignment Help Chemistry
Reference no: EM13173654

For the equilibrium

2H2S(g) <-> 2H2(g)+S2(g) Kc=9.0x10^-8 at 700 degrees C.
The initial concentrations of the three gases are 0.550 M H2S, .550 M H2, and .275 M S2. Determine the equilibrium concentrations of the gases.

Reference no: EM13173654

Questions Cloud

Define suburban boston municipal water system : A sample of drinking water collected from a suburban Boston municipal water system in 2002 contained 0.45 pCi/L of radon. Assume that this level of radioactivity was due to the decay
Development of a logical and well-structured response : Critical analysis of competing approaches/solutions to the issue and development of a logical and well-structured response to the issue
Explain higher or lower than the ph of a solution containing : Would the pH of a 0.10 M formic acid (HCOOH) solution be higher or lower than the pH of a solution containing 0.10 M formic acid and 0.10 M sodium formate
Explain unemployment rate : At the same time the unemployment rate remained at 8.3%. Use your understanding of the labor market to explain how these two things could happen at the same time.
Determine the equilibrium concentrations of the gases : The initial concentrations of the three gases are 0.550 M H2S, .550 M H2, and .275 M S2. Determine the equilibrium concentrations of the gases.
State the laboratory prevented an immediate analysis : Unfortunately, a mixup in the laboratory prevented an immediate analysis, and it was not until 17.0 days later that a measurement on the blood was made.
Primary research : Which of these documents would not qualify as primary research?
Calculate q, w and change in enthalpy for the helium : calculate q, w, and change in enthalpy for the helium in the balloon. (the molar heat capacity for helium gas is 28.8 J/ degrees C mol.)
Tradeoffs between inflation and the unemployment rate : Use the Phillips Curve to describe the tradeoffs between inflation and the unemployment rate, both in the short-run and in the long-run.

Reviews

Write a Review

Chemistry Questions & Answers

  Compute the molar mass of sucrose

Calculate the molar mass of sucrose. How many mol sucrose did you start with in this lab?

  State ice will be after the system reaches equilibrium

Assume the total heat capacity of the air C air=30 J/K. Describe what's the likely ice will ne after the system reaches equilibrium. b) Estimate theliekly final temperature after reaching equilibrium

  What is the speed of light

If a wave has a frequency of 6.9536 x 109 Hz and an energy of 4.6076 x 10-24 J, what is the speed of light.

  Calculate the final temperature

A 10.4-g sample of CaCl2 is dissolved in 107 g of water, with both substances at 25.0°C. Calculate the final temperature of the solution assuming no heat lost to the surroundings and assuming the solution has a specific heat capacity of 4.18 J/°C ..

  What is the maximum electrical work, in joules

A voltaic cell is based on the reaction Sn + I2 = Sn2+ + 2I-.

  Explain diprotic acids and solution equlibria

Diprotic Acids and Solution Equlibria, A 1.200 M solution of HCl is added to a solution containing 0.150 moles of sodium phosphate (Na3PO4). The resulting solution is then diluted to exactly 0.500 L

  State and draw the six conformers in newman projection

Draw the six conformers in newman projection for the 60 degree intervals from 0 to 360 degrees for carbon atoms 3 and 4. Clearly show which carbon is represented by the "dot" and the "circle" Show which C

  What is the molarity of na+ produced

If 1.00 g of Ca2+ dissolved in 420 mL of water reacts stoichiometrically according to the balanced equation in a reaction solution with a total volume of 1680 mL, what is the molarity (M) of Na+ produced?

  The wave function for the ground state of the quantum

The wave function for the ground state of the quantum harmonic oscillator

  Calculate the approximate molarity of this solution

Calculate the approximate molarity of this solution from the volume, percent composition, and density.

  Explain model of the enzyme substrate complex

In the first step of the trypsin mechanism, the side-chain oxygen of Ser 195 attacks the carbonyl carbon of the substrate. Use PyMOL and your model of the enzyme substrate complex to determine the distance between these two atoms.

  What is the new volume of gas in ml

A sample of gas occupies 721 mL at 1.00 atm. The pressure is increased to 1.1 atm (the temperature stays the same). What is the new volume of gas in mL?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd