Determine the dimension of this proposed footing

Assignment Help Civil Engineering
Reference no: EM13548080

A proposed square footing carrying a total load of 900 kips is to be constructed on a uniform thick deposit of cohesionless soil. The soil's unit weight is 135 pcf, and its angle of internal friction is 38 degrees. The depth of the footing is to be 4 feet. Determine the dimension of this proposed footing, using a factor of safety of 3.

Reference no: EM13548080

Questions Cloud

Design a concrete footing to support a 16in by 16 in column : Design a concrete footing to support a 16in by 16 in column that is 13 feet high with f'c= 6000 psi. The footing has a f'c=3000psi. Assume the the footing base is 5 ft below the grade and the soil is 100 lb/ft with an allowable pressure of 4500lb/ft ..
High level of activity consists of maintenance cost : High level of activity consists of maintenance cost - company to incur at an operating level of 70,000 directlabor-hours?
Estimated the required volume of the aeration tank : The town of Camp Verde has been directed to upgrade its primary WWTP to a second plant that can meet an effluent standard of 25 mg/L BOD5 and 30 mg/L suspended solids.
What annual volume savings will they achieve if they install : The Pomdeterra wastewater treatment plant produces thickened sludge that has a suspended solids concentration of 3.8 percent. They are investigating a filter press that will yield a solids concentration of 24 percent. If they now produce 33 m^3/d of ..
Determine the dimension of this proposed footing : A proposed square footing carrying a total load of 900 kips is to be constructed on a uniform thick deposit of cohesionless soil. The soil's unit weight is 135 pcf, and its angle of internal friction is 38 degrees.
Determine the foundation soils allowable bearing : A square footing 2 meters by 2 meters is to be constructed 1.22 meters below the ground surface. The groundwater table is located 1.82 meters below the ground surface. The subsoil consists of a uniform, medium dense, cohesionless soil with the follow..
Determine the factor of safety of this trench by the culman : A 1.5 meter deep vertical wall trench is to be cut in a soil whose unit weight is 17.36 kN/cubic meters, angle of internal friction is 25 degrees, and cohesion is 20.6 kN/square meters. Determine the factor of safety of this trench by the Culmann Met..
Estimate the maximum force that a water jet from : A pressure washer or power washer is a machine commonly used to clean mildew and dirt off houses, driveways, sidewalks etc. It attaches to a common garden hose
Interpret the slope. : Interpret the slope.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Find method to compute the flexural stresses for the load

Assume the section has cracked and use the transformed area method to compute their flexural stresses for the load. Given: Beam 30 ft long with uniform load of 2 k/ft and a point load of 30 k at 10 ft.

  Define the term coefficient of permeability

How would you define the coefficient of permeability? Give typical values of the coefficient for: a) fresh cement pastes; b) hardened cement pastes; c) commonly used aggregates;

  Find what is probability of failure with standard deviation

A column has a mean capacity of 950 kip. The standard deviation for the column capacity is 50 kip. The average load is 700 kip with a standard deviation of 75 kip. What is the probability of failure, pf

  What is the highest possible design speed for the curve

design a horizontal curve for a two-lane road. The road has 12-ft. lanes. Due to expansive excavation, it is determined that a maximum of 34 ft. can be cleared from the road's centerline toward the inside lane to provide for stopping sight distanc..

  Determine the compositions and quantities of gas and liquid

Determine the compositions and quantities of gas and liquid when 1 lb mole of a mixture of 30 mole percent methane and 70 mole percent ethanol is brought to equilibrium at 0 F and 500 psia.

  How much will it cost for one 15 minute episode of heating

A room 4x5x6 meter is heated by a baseboard resistance heater. We want the heater to raise the room temperature from 7 to 23 deg C in 15 minutes. There are no heat losses from the room, and specific heat may be assumed constant.

  How many moles of aluminum

How many moles of aluminum do 5.2×1024 aluminum atoms represent?

  Calculate the braking distance if only the rear brakes work

An automobile traveling at 30 miles per hour on level pavement with a coefficient of kinetic friction of 0.6. Weighs 3,000 lb. Sixty percent of its weight is on the front axle and 40% on the rear axle.

  What percent increase in shear force would be experience

What percent increase in shear force would be experience on the flat sides of a 40 ft long truck trailer as the truck speed increases from 65 mph to 75 mph. Kinematic viscosity of the air is 1.6x10^4 ft^2/s.

  Explain where the water is coming from for several decades

The Jordan aquifer has been pumped for several decades, yet remains fully saturated. Explain where the water is coming from.

  Calculate the co-efficient of permability of the soil

In a falling-head permeability test the initial head of 1.5m dropped to 0.5m in 4 h the diameter of the standpipe being 5mm. The soil specimen was 200mm long by 100mm in diameter.

  Determine the mass flowrate through boiler

The inlet of loe pressure turbine is 500Kpa and 500°C. Condenser operates at 10 Kpa. Determine the mass flowrate through boiler needed to produce 5000KW of power.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd