Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A trapezoidal channel is to be excavated in alluvial material on a bed slope of 1:10000. The side slopes will be 1(vertical) : 2(horizontal). Details of the bed material are as follows:
Particle diameter 4 mmParticle density 2650 kg/m3Angle of internal friction 30°Manning n 0.02
Determine the depth of flow if the flow is to be non-erosive.
A 400ft equal-tangent sag vertical curve has its PVC at station 200 + 00 and elevation 250ft. The initial grade is -5.0% and the final grade is +2.5%. Determine the elevation of the lowest point of the curve.
a ballon weighing 3.5 lb is 6 ft in diameter. if filled with hydrogen at 18 psia and 60 degrees F and released, at what U.S standard altitud will it be neutral
What type of exercise takes place in a classroom setting arranged to look like an emergency operations center or in an actual emergency operations center, and involves simulation using written, telephone, and radio messaging.
The cross sectional dimensions of a 4-ft-long wood member at 30% moisture content is 1.5 in. x 7.5 in., and its weight is 11 lb. At oven-dry condition, its dimensions and weight are 1.35 in x 6.8 in., and 10.2, respectively. What is its specific g..
The knowledge of the geological and geotechnical characteristics of the subsoil is a basic step, fundamental to the development of any type of research, evaluation, study or project in the areas of Civil and Environmental Engineering.
At the beginning of compression the pressure is 14 psi and the temperature if 60°F. The temperature at the end of combustion heat addition is 1500°F and the compression ratio is 9. Use constant specific heats at room temperature
How to draw bending moment diagram for this shape and the value of the moment in critical sections assume that the distributed load (w) KN/M and the concentrated load
The yield stress for A-36 is 250 MPa. Using factor of safety against yield of 1.25, determine an appropriately sized beam such that the radius of curvature is not less than 140m. E= 200 GPa, G= 77.2 GPa.
Determine the velocity of slider block C at t=0, (b) the acceleration of A and C, (c) the change in position of block A after 5s.
The beam is subjected to a force F=825 lb in the direction, and is supported by a pin connection at point B and a rope attached through a pin connection at point A. Problem #1: Draw a complete FBD of the beam.
When the larger ball hits the ground and then collides with the smaller ball, it causes the small ball to bounce to a height several times greater than that from which the balls were originally released.
The length of the pipeline in the building is 60 m, the water temperature is 20.C, and the water pressure on the top floor must be at least 150 kPa. Will a booster pump be required for the building If so, what power must be supplied by the pump
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd