Determine the deflection angle to the last full station

Reference no: EM13563812

1.Determine the number of bricks and cubic feet of mortar required for 100 square feet of wall. the ties are to be spaced 16 inches on center vertically and 24 inches on center horizontally

2.Calculate the chord lenght between stations 75.00 and 75.00 on a circular curve with Da=5.5 degrees. (arc definition)

3.Determine the deflection angle to the last full station on a horizontal curve with Da=3 degrees. The PI is located at station 12.20 and the central angle is 24 degrees.

4.Air enters adiobatic compressor at 100kpa, 20 degrees celcius at rate of 0.1 kg/s and exits at 200 degrees celcious. compressor efficiency is 70%. Determine the exit pressure and power required.

Reference no: EM13563812

Questions Cloud

Describe the problem of lack of coordination between design : Describe the problem of lack of coordination between design and construction in a traditional contract.In agency CM,what expertise does the CM provide during the pre-design and design phase?

Determine if the process is possible from the second law : Steam at 800kpa and 300 degree celsius exists in the large supply line. when the valve opened from the large supply the steam enters into an empty, evacuated tank with a volume of 0.3m cube

What is the offset at the midpoint on the curve : A vertical curve with grade1= 3.6% meets the exit grade of -4.7% at PVI located at station 26.50. A vertical curve of 700 feet is propsed to provide the transition between the two grades

Calculate the loss of pressure which will occur in the pipe : An 180 m long 100 mm diameter compressed air pipeline is to be run from a stationary compressor to an air-track drill which requires a flow of 780 l/sec. The pipeline contains 2 large radius bends (R=2d) ,and 4 half closed gate valves.

Determine the deflection angle to the last full station : Air enters adiobatic compressor at 100kpa, 20 degrees celcius at rate of 0.1 kg/s and exits at 200 degrees celcious. compressor efficiency is 70%. Determine the exit pressure and power required.

Describe the two different types of overhead costs : Describe an engineer's estimate.Describe the two different types of overhead costs.Describe HeavyBid and how it is used.How does the hierarchy approach in HeavyBid program assist in the identification or resources?Describe what contractors who do not..

What is the maximum constriction before the depth : A river upstream of a brdige corssing is 3 meters deep and has an average velocity of 3 m/s. The bridge piers cause a constriction in the width of the flow by 12%.

Explain how mechanical strength melting temperature : Explain how mechanical strength, melting temperature , and thermal exapntion are related at the atomic level. specifically, how do they relate to each other and the bonding energy between the atoms

What is the tension force in the bolts holding the bend : When a plastics plant is redesigned, a tank exit is now facing the wrong direction and must be connected to a pipe of diameter D=0.2 m with a180o bend in a horizontal plane.

User Account

All Pages