Determine the concentration and temperature

Assignment Help Civil Engineering
Reference no: EM13210948

Two immiscible fluids are in contact. Fluid I is denser and is also well mixed. The concentration of species a is cao everywhere within this fluid and the temperature in fluid I is held constant at To. Species a diffuses through stagnant fluid II and undergoes a first order to form species b within the fluid. Assume constant properties for both phases. The reaction occurs having a rate constant of k'' and is occuring in an exothermic manner, giving deltaHr joules per mole of a reacted. The following boundary conditions apply at x=0, ca = Keqcao and T=To and at x=L, (dco/dx)=0 and (dT/dx)=0. Determine the concentration and temperature profiles for this system.

Reference no: EM13210948

Questions Cloud

Determine the force members bc, fc, and fe : Determine the force members BC, FC, and FE, and state if the members are in tension or compression.
Compose a list here of the geological terms : compose a list here of the geological terms that you encounter in this reading that you could not define and explain in a test situation.
A calcium chloride solution from calcium chloride anhydrous : How to prepare ml of 0.2ml of calcium chloride solution from calcium chloride anhydrous or from calcium chloride dihydrate?
Does arrangement violate OSHA standards for fall protection : Painter is standing on a work platform that is 27 feet above ground level. For fall protection, the worker’s safety harness D-ring is attached to a 12-foot shock absorbing lanyard that is securely fastened to the structure at a point 40 feet above gr..
Determine the concentration and temperature : The following boundary conditions apply at x=0, ca = Keqcao and T=To and at x=L, (dco/dx)=0 and (dT/dx)=0. Determine the concentration and temperature profiles for this system.
What is the risk of constructing a harbor : What is the risk of constructing a harbor which will be unprotected from wave attack during its construction.
Describe a dynamic programming algorithm : Describe a dynamic programming algorithm to find an independent set of T such that the sum of numbers of nodes in the set is the largest among all possible independent sets of T.
Explain molecular formula and 1h nmr spectrum : Give the structure that corresponds to the following molecular formula and 1H NMR spectrum: C4H10O2: ? 1.36 (3H, d, J = 5.5 Hz); ? 3.32
Discuss the life span perspective of human development : In which you discuss the life span perspective of human development. Summarize three theories related to human growth and development and identify at least one influential theorist for each.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Analyze the stability of the dam

Analyze the stability of the dam shown in the figure, if the friction coefficient between concrete and foundation is 0.70, and the specific weights of concrete and water are 24kN/m 3 and 10kN/m 3 , respectively.

  Investigate the possibility of environmental problems

Investigate the possibility of environmental problems that faced by the area of disaster.

  Engineering ethics and concept and cases

what is the engineering ethics case related to civil engineering with reference and discuss all the engineering ethics issues which covered the "Engineering etics concepte and cases?

  Determine the factors of safety against sliding

assume hydrostatic uplift varies uniformly from full hydrostatic head at the heel of the dam to zero at the toe. consider 1m length of dam.

  F-m ration for conventional activated sludge plant

A 4000-m 3 /day conventional activated sludge plant has an influent with a BOD5 of 190 mg/L and SS of 225 mg/L. What population would this plant serve?

  Highest point of the piping system

a) The maximum flow rate that can be achieved without cavitation occurring in the piping system. b) The maximum elevation of the highest point of the piping system to avoid cavitation.

  Magnitudes of the additional loads

Determine the magnitudes of the additional loads that must be applied at B and F if the resultant of all six loads is to pass through the center of the mat.

  Annual power cost of the ro system

Is the system within membrane manufacturer's warranty requirement of maximum flux rate of 14 gfd? What is the annual power cost of the RO system?

  Magnitude of shaft work obtained from the turbine

If the amount of heat transfer in the HE unit is 2460 kJ per kg of steam, what is the magnitude of shaft work obtained from the turbine in kW?

  Maximum height of its centre of gravity

If a mass of 500kg is placed centrally on the top face of the buoy, find the maximum height of its centre of gravity above the bottom of the buoy so that the buoy may remain in stable equilibrium.

  Describe the present land capability classification system

Describe the present land capability classification system for agriculture in the caribbean, Identifying its limitations and propose recommendations. 200 word limit

  Horizontal axle passing through center

A 75g , 30cm--long rod hangs vertically on a frictionless, horizontal axle passing through its center. A 12g ball of clay traveling horizontally at 2.5m/s hits and sticks to the very bottom tip of the rod.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd