Determine the anualvolume of solid waste produced by

Assignment Help Civil Engineering
Reference no: EM13529942

Solid waste management

the Bailey stone work employs six people. assuming that thedensity of uncompacted waste is 480 kg/m^3 determine the anualvolume of solid waste produced by the stone works assuminga wastegeneration rate of 1kg/cap *d

Reference no: EM13529942

Questions Cloud

Calculate the overflow rate detention time and weir loading : A fine sand has a hydraulic condutivity of 3.5 x 10^-5 m/s a hydraulic gradient of 0.00141, and a porosity of 45 percent. Detrmine the Darcy velocity and the averge linear velocity
Find the average mechanical power output of the heart : A patients heart pumps 4.2L of blood per minute into the aorta, which has a diameter of 2.2cm. find the average mechanical power output of the heart
An unknown immiscible liquid seeps into the bottom of an : An unknown immiscible liquid seeps into the bottom of an openoil tank. Some measurements indicate that the depth of theunkown liquid is 1.5m and the depth of the oil ( specific weight =8.5
Find the magnitude of the hanging blocks acceleration : Two blocks are connected by a string. The smooth inclined surface makes an angle of 35 degree with the horizontal, Find the magnitude of the hanging block''s acceleration
Determine the anualvolume of solid waste produced by : The Bailey stone work employs six people. assuming that thedensity of uncompacted waste is 480 kg/m^3 determine the anualvolume of solid waste produced by the stone works assuminga wastegeneration rate of 1kg/cap *d
Obtain the potential difference between the two points : A uniformly charged infinite sheet with a surface charge density +? lies flat in the x-y plane. What is the potential difference DV between the two points
Give the phase and the missing property of : Give the phase and the missing property of P, T, v and x. Put the values in a table withcolumns P, T, v, and x.
What is the maximum amount of soluble : If the solubility product of magnesium hydroxide is 11.25 answerthe following question. If water at 25-degree C is bufferedsuch that the pH remains fixed at 7, what is the maximum amount ofsoluble Mg2+, in grams, in 1L of water?
How fast are is he going at the bottom : The skier starts at a snow covered slope which is inclined 20 degrees above the horizontal. The skier has a mass of 100kg. How fast are is he going at the bottom

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the equivalent overflow rate in gpd per ft squared

The settling velocity of alum floc is approximately 0.0014 fps in water at 10 degrees celsius. Calculate the equivalent overflow rate in gpd/ft squared. What is the minimum detention time in hours

  Compute the maximum acceptable service load

Compute the maximum acceptable service load on an A36 steel plate tension member 1/4in.x12in. having a single line of holes parallel to the direction of loading. The load is 25% dead load and 75% live load, and 7/8in. diameter bolts are used.

  Determine the maximum negative moment in each span

determine the maximum negative moment in each span and maximum negative moment at each support. remember that live loads shall be placed so as to cause the greatest effect. specify the method that you used to determine the moments.

  Compute dead load due to backfill that the pipe must support

A 300 mm diameter pipe is placed in a 3 m deep rectangular trench that is 0.60 m wide. The trench is backfilled with clay that has a bulk unit weight of 18.8 kN/m3. Compute the dead load due to backfill that the pipe must support.

  What will be the total cost per lane-mile per inch depth

If an alternative base material is available for $5,791.50 per lane-mile per inch depth, to use it, the minimum depth for asphalt has to be increase to 6 inch with no change of base and subbasedepth. What will be the total cost per lane-mile per i..

  How to assume a weight od 150 pcf for reinforced concrete

it carries a uniform service load of 2450 lb/ft in addition to its own weight. material strengths are f'c=4000psi and fy=60000psi .assume a weight od 150 pcf for reinforced concrete.

  Determine the instantaneous center of rotation of the spool

Knowing that end B of the tape is pulled downward witha velocity of 300 mm/s and that at the instant of the total thickness of the tape on the spool is 20 mm, determine (a) the instantaneous center of rotation of the spool,

  Determine the amount of the energy losses in meters

A rectangular channel carries a discharge of 2.00 m3/sec per meter of channel width over a weir crest that is 1.4 m in height. The energy grade line upstream of the weir measure 2.7 m above the channel bottom.

  Determine what is the angle theta required for equilibrium

Rope segment BC creates an angle of phi2 = 74.0^\circ with the floor and rope segment CD creates an angle theta with the horizontal. If both ropes BCA and CD can support a maximum tensile force T3 = 130 lb,

  Determine the increase in the temperature of the river

A power plant operates at steady-state. It receives energy from a hot source (combustion of fuel) at a temperature of 420 oC. The plant discharges this energy to a nearby river that acts as a cold source.

  Is inventor claim valid to have an invented adiabatic flow

An inventor claims to have invented an adiabatic steady-flow device with a single inlet-outlet that produces 100 kW when expanding 1 kg/s of air from 900 kPa and 300 degrees C to 100 kPa.

  Sufficient collapse strength

Would a 30 slot stainless steel screen (2.0 m long; located at the bottom of the well) have sufficient collapse strength for this application?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd