Determine the amount of money saved per year associated

Assignment Help Civil Engineering
Reference no: EM13312122

A 2005 Chrysler Town and Country MInivan has a frontal area of 2.9m2 and a drag coefficient of 0.35. A 2000 Honda Insight has a frontal area of 1.9m2 and a drag coefficient of 0.25. Determine the amount of money saved per year associated with aerodynamic drag reduction as a result of switching from the Chrysler to the Honda. Assume 12,000 miles per year at an average speed of 55 miles per hour. Use this gasoline data: price $3.50/gal, energy content 1.3 x10^8 J/gal. Assume an engine efficiency of 30%. Note the savings you would estimate by simply looking up the "miles per gallon" ratings of these cars may be higher due to the factors other than aerodynamic drag.

Reference no: EM13312122

Questions Cloud

Determine the concentration of ammonia in the solution : A solution is prepared by dissolving 0.15mol of acetic acid and 0.15mol of ammonium chloride in enough water to make 1.0 L of solution. Find the concentration of ammonia in the solution.
How much time will the clock on the moon lag the clock : Suppose a space colony is established on the moon. how much time will the clock on the moon lag the clock
Explain the glass piece into compression : Glass tempering can be accomplished by both thermal and chemical means. Each puts the near surface region of the glass piece into compression, thereby suppressing growth of surface cracks.
What is the force on the bottom of the tank : The water in a tank is at a gauge pressure of 259,145 Pa. If the bottom of the tank that has an area of 0.5 m2
Determine the amount of money saved per year associated : A 2005 Chrysler Town and Country MInivan has a frontal area of 2.9m2 and a drag coefficient of 0.35. A 2000 Honda Insight has a frontal area of 1.9m2 and a drag coefficient of 0.25.
Determine the radial acceleration of the car at this time : A car at the Indianapolis-500 accelerates uniformly from the pit area, going from rest to 340 km/h in a semicircular arc with a radius of 194 m. Determine the radial acceleration of the car at this time
Determine a suitable set of pi terms for the model : In a given experiment it is determined that the pressure change (deltaP) between two points in a pipe is dependent upon the density(p) of the fluid, the diameter(D) of the pipe, and the velocity(V) of the pipe.
Compute the potential difference between the birds feet : A bird sits on a high-voltage power line with its feet 5.2 cm apart. What is the potential difference between the bird's feet
Set up the marketing strategy : Research Proposal For Promoting The Green Building Into HK Society: Set Up The Marketing Strategy

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the nominal strength with one end fixed

The length is 10 feet. What is the nominal strength if Fy=50 ksi. Note that this is a slender-element compression member, and the equations of AISC section E7 must be used

  Compute the convective heat transfer coefficent

Water at a flow rate of 1 kg/s is flowing in a pipe of internal diameter 5 cm. If the inside pipe surface temperature is 90 degrees C and mean bulk water temperature is 50 degrees C

  What is the astronomic azimuth of the line

The magnetic north azimuth of a line is 128 degrees 27' while the magnetic declination is 3 degrees 30'E. What is the astronomic azimuth of the line (in decimal degrees)?

  Determine the ratio of the mean velocity to the max velocity

velocities in a 200-mm-diameter circular conduit, measured at radii of 0,36,64, and 87 mm were 7.0, 6.8, 6.1, and 5.0 m/s, respectively. Find the approximate values (graphically) of the volume flow rate and the mean velocity.

  Determine reduced live load supported by exterior column

A 45-cm-thick, 300-cm-high lightweight concrete masonry unit wall lies on a 20-cm-thick lightweight plain concrete slab. The 20-cm wide slab is supported by a reinforced concrete beam, which is placed on top of two columns (simply supported beam).

  Calculate earth gravitational force

Calculate Earth's gravitational force on the Shuttle astronauts while orbiting at an altitude of 220 miles (or 354 km) above Earth's surface.

  Calculate mass of sludge wasted each day for sludge system

A wastewater treatment plant has a flow of 35,000 m3/day. Calculate the mass of sludge wasted each day (QwXw, expressed in kg/day) for an activated-sludge system operated at a solids retention time (SRT) of 5 days

  Determine the head loss caused by the piers

A bridge has cylindrical piers 1 m in diameter and spaced 15 m apart. Downstream of the bridge where the flow disturbance from the piers is no longer present, the flow depth is 2.9 m and the mean velocity is 2.5 m/s.

  Freeways density and level of service

What will the freeway's density and level of service be before and after the ban? (Assume that the trucks are removed and all other traffic attributes are unchanged).

  Use differentiation to find a general expression

(a) Use differentiation to find a general expression for the rocket's velocity as a function of time, (b) When is the velocity zero?

  Calculate the peak bending moment for the roof beam

Calculate the peak bending moment for the 4x10 roof beam. Then draw a clear dimensioned FBD for the two exterior bearing walls above the floor joists, no moment calcs here.

  Estimate range of piezometric head differences to be used

A field sample of medium sand with median grain size of 0.84 mm will be tested to determine the hydraulic conductivity using a constant-head permeameter. The sample has the length of 30 cm and a diameter of 5 cm.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd