User Account

All Pages

Determine the 60-hz resistance of the line in ohms

Assignment Help Electrical Engineering
Reference no: EM13229550

A 60-Hz, 765-KV three-phase overhead transmission line has four ACSR 900 kcmil 54/3 conductors per phase. Determine the 60-Hz resistance of this line in ohms per kilometer per phase at 50 degrees Celsius.

Reference no: EM13229550

Questions Cloud

Examine the role of advertising and promotion management : Examine the role of advertising and promotion management in contemporary marketing and develop an understanding of integrated marketing communications, including the coordination of the various promotional mix elements
Find the reflection coefficient at the load : A 75- ohm lossless transmission line is interfaced to a load impedance that consists of a series connected resistor of 30 ohm and a capacitor of 10 pF. At an operating frequency of 2 GHz and for a wavelength of 10 cm.
Determine the total power in fm signal : An FM signal being transmitted is represented by eFM(t) = 50Sin((2)(95.1)(106)t+2Sin((2)(10)(103)t)). If the antenna impedance is 75 , determine: (a) total power in FM signal and (b) FM modulation index.
What is the adt output for a temperature of 81 degrees : A HCS12 ATD is set to 10-bit unsigned mode. The voltage references are set to ground and 1.0V What is the ADT output for a temperature of 81 degrees The temperature sensor measures 0 to 100 degrees with an output of 10 mV/degree.
Determine the 60-hz resistance of the line in ohms : A 60-Hz, 765-KV three-phase overhead transmission line has four ACSR 900 kcmil 54/3 conductors per phase. Determine the 60-Hz resistance of this line in ohms per kilometer per phase at 50 degrees Celsius.
Compute the molar solubility : The Ksp of AgCrO4 is 1.9 x 10^-12. Calculate the molar solubility (in mol/L) of Ag2CrO4 in 0.1 M AgNO3.
How the temperature switch turns on the white pilot light : PLC 2 In a motor control system, one master stop pushbutton (Stop) is available for stopping the operation at any time. If the temperature switch (TSW) is closed, pressing the red pushbutton (RedPB) will turn on both motors M1 and M2.
Explain what is the maximum concentration of ba2 : What is the maximum concentration of Ba2+ that can be added to a solution containing 1.5 X 10^-2M of F- without precipitating BasF2? Ksp = 1.7 x 10^-6
Define what molarity of aqueous aluminum sulfate solution : What molarity of aqueous aluminum sulfate solution can be expected to show the same conductivity as 0.015 M Na2SO4 at 18,000 units?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine what is the switching voltage

Suppose that two optical guides embedded in a substrate such as LiNbO3 are coupled as in the below figure and the transmission length Lo=10mm. If the coupling separation d is =10µm, n = 2.2, the operating wavelength is 1.3µm

  Develop an input-output port decoder

Develop an I/O port decoder, using a PLD, that generates 16-bit I/O strobes for the following 16-bit I/O addresses: 1000H-1001H, 1002H-103H, 1004H-1005H, 1006H-1007H, 1008H-1009H, 100AH-100BH, 100CH-100DH, and 100EH-100FH.

  Calculate the output resistance of the device

Calculate the output resistance of the device, dIC/dVC, for 0

  Find the fourier series of the signal in frequency domain

A discrete periodic signal shows the signal characteristics in one period as below. find the Fourier Series (FS) of this signal in frequency domain. write down in detail of your procedures. 1; n=1 0; n=0 x[n]{ -1; n=1 1/2; n=2 3; n=3.

  Estimate the diffusivity of a spherically shaped protein

Estimate the diffusivity of a spherically shaped protein with a MW of 36,000 in water at 37oC.

  Design a parallel resonance circuit with resonance frequency

Design a parallel resonance circuit with resonance frequency of 30kHz and bandwidth of 20kHz and plot its frequency response.

  What is the actual value of the irr on the incremental cost

a) Construct a choice table for interest rates from 0% to 100%. b) Which roof should you choose if your MARR is 12% what is the actual value of the IRR on the incremental cost?

  Explain received power of half-wave dipole antennas

Received power of half-wave dipole antennas, Assume that two antennas are half-wave dipoles and each has a directive gain of 3dB. If the transmitted power is 1W and the two antennas are separated by a distance of 10 km, what is the received power?

  Interface binary i/o devices to the microcontroller

Interface binary Input Output devices to the microcontroller

  Explain complex power

Question about Complex power, If an electrical load operates at 240 Vrms.The load absorbs an average power of 8kW with .8 lagging power factor

  Determine a time-domain sequence of dft

Let x[k] be a time-domain sequence and X[r] be its DFT. (When written as vectors, unless stated otherwise, always assume the first entry in the vector is at k=0 or r=0, respectively.) If x[k] = [5, 9, 6, 10]

  What are the design implications for the location

What are the design implications for the location and positioning of solar cells? Explain why the use of solar cells might be more appropriate in some regions of the country.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd